IE-789835-NS-EM1 Renesas Electronics America, IE-789835-NS-EM1 Datasheet - Page 38

• Manufacturer Part Number: IE-789835-NS-EM1
• Description: BD EMU 78K0S UPD789832/33/34/35
• Manufacturer: Renesas Electronics America

Specifications of IE-789835-NS-EM1

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

target interface circuit.
comprising the emulation CPU, TTL, CMOS-IC, etc. The protective circuit makes the electrical specifications of the
IE system different from those of the target device.
(1) Signals input to or output from the EVA chip and the peripheral EVA chip
(2) Signals input from the target system via a gate
(3) Other signals
alternate pins for which no circuit is provided in the IE system.
(1) Signals input to or output from the emulation CPU
36
CHAPTER 4 DIFFERENCES BETWEEN TARGET DEVICES AND TARGET INTERFACE CIRCUITS
This chapter describes differences between the target device’s signal lines and the signal lines of the IE system
The target interface circuit of the IE system realizes emulation through an emulation circuit configuration
The following shows the circuit of the IE-789835-NS-EM1 for the signals in (1) to (3) above. The same applies to
The following signals perform the same operations as in the µ PD789835 Subseries. However, a 1 MΩ pull-down
resistor and 100 Ω resistor are inserted in series. Refer to Figure 4-1 Equivalent Circuit of Emulation Circuit
1.
1 MΩ pull-down resistors are connected to the signals related to port 0 and port 1 inside the IE-78K0S or IE-
78K0S-NS-A.
• Signals related to port 0
• Signals related to port 1
• Signals related to port 2
• Signals related to port 3
• Signals related to port 6
• Signals related to port 8
• Signals related to LCD
V
V is connected between V
LC0
When used as pins for detecting key returns, port 0 is pulled up using HC4066 in the IE-789835-NS-EM1.
to V
LC4
and CAP0 to CAP3 are connected to the emulation circuit by switching slide SW. A Zener diode of 7
LC0
and GND to protect the pins.
User’s Manual U16290EJ1V0UM