ADNK-6033-ND24 Avago Technologies US Inc., ADNK-6033-ND24 Datasheet - Page 2

• Manufacturer Part Number: ADNK-6033-ND24
• Description: KIT REFERENCE DESIGN ADNS-6030
• Manufacturer: Avago Technologies US Inc.
• Series: LaserStream™r
• Type: Optical Mouser

Specifications of ADNK-6033-ND24

• Contents: Laser Mouse Sensor, Accessories and Documentation
• Wireless Frequency: 2.4 GHz
• Interface Type: USB
• For Use With/related Products: ADNS-6030, MSP430F122
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Figure 1. Sectional view of PCB assembly highlighting all optical mouse components
(optical mouse sensor, clip, lens, LASER, PCB, and base plate).
The Texas Instruments MSP430F1222 is the ultra low-
power mixed signal microcontroller with a built-in
16-bit timer, 10-bit A/D converter with integrated refer-
ence and data transfer controller (DTC) and twenty-two
I/O pins. In addition, the MSP430F1222 microcontroller
has built-in communication capability using asyn-
chronous (UART) and synchronous (SPI) protocols. The
architecture, combined with five low power modes is
optimized to achieve extended battery life on wireless
application.
The Nordic nRF2402 and nRF2401A are the low power
single-chip radio transmitter and transceiver for the
world wide 2.4 - 2.5 GHz ISM band. The entire transmit-
ter and transceiver including all inductors and filters
are integrated in each single chip respectively which
gives the lowest cost solution to the end user. All con-
figurations of the nRF2402 transmitter and nRF2401A
transceiver are done via a standard serial interface. The
nRF devices include the ShockBurst engine which allow
for high datarates on air using low datarates between
the microcontroller and the nRF device, it will also au-

PLATE
BASE
SENSOR
LENS
SURFACE
VSCEL
PCB
tomatically validate the packets adress and CRC, further
reducing the microcontrollers processing tasks.
The Cypress CY7C63231A enCoRe is a revolutionary
chip that integrates numerous common components,
including breakthrough crystal-less oscillator. The re-
sult is an overall reduction in board components and
reduced system cost. The EPROM based microcontroller
allows easy firmware modification, as well as storage
of Vendor and Product IDs without an external EE-
PROM.
This kit is connectable to a PC via the USB port. It is
based on the 2.4GHz RF technology, the data gener-
ated from displacement detection / button status in
the laser mouse is encoded with a pre-defined serial
type protocol handled by firmware in the MCU. In the
RF stage, the encoded data is used for GFSK modula-
tion. The captured data from the RF receiver stage is
decoded with a corresponding packet format used for
mouse applications. The final data is sent to the host
through the USB interface.
VSCEL
CLIP
PCB