ST92F150-EPB/US STMicroelectronics, ST92F150-EPB/US Datasheet - Page 7

• Manufacturer Part Number: ST92F150-EPB/US
• Description: BOARD PROGRAM FOR ST92F150 MCU
• Manufacturer: STMicroelectronics

Specifications of ST92F150-EPB/US

• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 497-3100

ST9 EPB User Manual
2
2.1
2.2
Note:
Note:
GETTING STARTED
Delivery Checklist
Check that your ST9 EPB programming board kit contains the following items:
•
•
•
•
•
Setting up the EPB
To set up the ST9 EPB hardware, follow these instructions:
1
2
Be sure to use the parallel cable provided with your kit—using a longer parallel cable may
cause malfunctions.
Connect the cable directly between the host PC and the programming board—the insertion of
additional cables or switch boxes between the host PC and the programming board may
cause malfunctions.
If a dongle (a hardware key required by some software packages) is already connected to the
PC’s parallel port, it should not interfere with the programming board. However, if a
malfunction of the board should occur, please remove the dongle and restart the above
sequence.
3
The board can be supplied from the integrated power supply provided with the board, or from
an external +15 V
4
1 ST9 EPB Eprom Programming Board (i.e. the EPB appropriate to the sales
type ordered).
1 power supply.
1 parallel cable.
1 MCU on CD CDROM containing the STVP9 software.
1 14-pin HE10 type ribbon cable for ISP mode (if provided on the programming
board for the sales type ordered).
Shut down and power-off the host PC.
Connect one end of the supplied parallel cable to connector P1 of the ST9 EPB
and the other end to one of the host PC’s parallel ports (LPT1 or LPT2).
Power on the programming board by connecting the power supply to the
programming board and to the mains. Ensure that the power supply is adapted
to the mains voltage and outlet type used in your country.
Power on the host PC and install the software provided as described in the next
section.
DC
/ 0.5 A power supply.
2 - Getting Started
7/24