ZGP323ICE01ZEM Zilog, ZGP323ICE01ZEM Datasheet - Page 14

• Manufacturer Part Number: ZGP323ICE01ZEM
• Description: PLATFORM DEV ICE Z8 GP ZGP323
• Manufacturer: Zilog

Specifications of ZGP323ICE01ZEM

• Processor To Be Evaluated: ZGP323
• Interface Type: RS-232, Ethernet, USB
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 269-3399; ZGR323ICE01ZEM

UM017503-0208
Note:
The emulator console prompt is not case-sensitive.
3. Enter the name for a new connection in the Connection Description dialog, and click
4. In the Connect To dialog, set the Connect Using drop-down menu to match the COM
5. A COM Properties dialog appears. Enter the following port settings and click OK.
6. When the emulator is turned ON or reset, a Z8 GP ICE console boot-up message
ZiLOG Z8 LXM ICE
Firmware Version 2.0, Build (Aug 22 2005 08:14:37)
Copyright (C) 2005 ZiLOG, Inc. All Rights Reserved.
Adding emac driver...
Attempting to establish Ethernet connection.
10 Mbps Half-Duplex Link established
IP Address: 10.1.7.95
IP Subnet: 10.1.0.0/255.255.0.0
IP Gateway: 10.1.1.254
Press 'Ctrl-Z' to enter configuration mode
7. Press Ctrl-z. The emulator command prompt appears:
Type
For information on the description of the complete Z8 GP ICE commands, see
A—Z8 GP ICE Commands
8. When you have finished configuring the emulator, type
9. Press Alt+F4 to exit HyperTerminal.
10. Cycle the power on the Z8 GP ICE for the new settings to take effect.
OK to open the Connect To dialog box.
port to which the Crimzon ICE is connected. Click OK.
HyperTerminal should automatically attempt a connection. Otherwise, select Call
Connect.
appears in the HyperTerminal. A typical boot-up message is provided below:
Z8 LXM ICE %
shell.
Bits per second
Data bits
Parity
Stop bits
Flow control
help
or
?
Z8 GP
at the emulator command prompt to see the list of available commands.
™
57600
8
None
2
None
ZGP323 In-Circuit Emulator and Development Platform
on page 23.
exit
to exit the command
User Manual
Introduction
Appendix
→
11