ZGP323P4010ZAC Zilog, ZGP323P4010ZAC Datasheet - Page 12

• Manufacturer Part Number: ZGP323P4010ZAC
• Description: KIT ACCESSORY Z8 GP ZGP323 40DIP
• Manufacturer: Zilog

Specifications of ZGP323P4010ZAC

• Accessory Type: Target Pod Accessory Kit
• Processor To Be Evaluated: ZGP323
• Interface Type: RS-232, Ethernet, USB
• For Use With/related Products: Z8 GP ZGP323
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 269-3744

Page 12
Z8 GP™ ZGP323 In-Circuit Emulator and Development Platform
User Manual
3. In the Connect To dialog, set the
4. A COM Properties dialog appears. Enter the following port settings and click OK.
5. HyperTerminal should automatically attempt a connection. If not, select
6. When the emulator is turned on or reset, HyperTerminal displays a Z8 GP ICE console
7. Press ctrl-z. The emulator command prompt displays:
8. Type help or ? at the emulator command prompt to see a list of available commands.
Configure the Hardware
Note:
port to which the Z8 GP ICE is connected. Click OK.
Call --> Connect.
boot-up message in HyperTerminal. A typical boot-up message is shown below.
The following list displays:
Command usage is described in Table 3.
Bits per second:57600
Data bits:8
Parity:None
Stop bits:2
Flow control:None
ZiLOG TCP/IP Software Suite v1.1
Copyright (C) 2004 ZiLOG Inc.
All Rights Reserved
clock enabled
IP Address: 192.168.1.50
IP Subnet: 192.168.1.0/255.255.255.0
IP Gateway: 192.168.1.254
Z8 ICE Firmware x.x (Dec
Copyright (C) 2001-2003 ZiLOG, Inc.
All Rights Reserved.
Press 'Ctl-Z' to enter configuration mode
eth1 %
Commands are:
eth1 %
?
help
mem
restore
The emulator console prompt is not case-sensitive.
debugport
ifconfig
password
Connect Using:
5 2003 13:45:05)
drop-down menu to match the COM
devs
kbuf
ps
UM019302-0407
exit
kill
reboot