RTA-FOUSB-MON Renesas Electronics America, RTA-FOUSB-MON Datasheet - Page 11

• Manufacturer Part Number: RTA-FOUSB-MON
• Description: ON CHIP DEBUG EMULATOR
• Manufacturer: Renesas Electronics America
• Type: FLASHr

Specifications of RTA-FOUSB-MON

• Contents: USB Compact Flash Programmer, USB Cable, CD-ROM and User Manual
• For Use With/related Products: M16C Family and 740 Family
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

This pin is used to enter boot mode for programming of the target M16C MCU. Not all M16C MCU’s have
a CE pin. If a CE pin exists on the target MCU, it should be connected to this pin (refer to serial mode
flash programming in the target MCU’s datasheet). If not, leave pin unconnected.
If the target MCU’s CE pin is used as input, isolate the driving circuit from the header connection with a
1Kohm resistor.
If to be left unconnected (if users decides to), care must be taken to ensure that the target MCU’s CE pin
has a high signal level using a pull-up resistor during any programming operations.
In Target Power Mode, the pin is used to control target MCU’s EPM pin (if it exists on the target MCU).
EPM pin is used during programming of the target MCU. If this pin exists on the target MCU, it should be
connected to the header (refer to serial mode flash programming of the target MCU’s datasheet). If not,
leave unconnected.
If the target MCU’s EPM pin is used as input, isolate the driving circuit from the header connection with a
1Kohm resistor.
If the EPM pin of the M16C MCU is left unconnected (no external circuit and not connected to 10-pin
header), care must be taken to ensure that the target MCU’s EPM pin has a low signal level using a pull-
down resistor during any programming operations.
This provides the common point where the ICD ground and target board ground planes can be
connected. This must be connected to target board’s GND line/plane.
This active low signal is used by the ICD to reset the target MCU. This must be connected to the target
board’s reset circuit or target MCU’s reset pin.
The user must ensure that the ICD can drive the pin to a valid low level with 5mA current.
This active high signal is used by the ICD to control the target MCU’s CNVss pin for programming
purposes. This must be connected to the target MCU’s CNVss pin. During normal operation, this pin must
have a low signal. To accomplish this, connect a 10K (nominal) pull-down resistor. See M16C MCU
datasheet on CNVss pin description for details.
This is the ICD SIO receive data input. This must be connected to the target M16C MCU’s boot
UART/SIO transmit data output (TXD) pin.
This pin may be used for other applications as long as the user ensures that the ICD can drive the pin to
valid levels with 5mA current.
RTA-FOUSB-MON User’s Manual Rev 2.2
5. CE Pin
6. EPM Pin (in Target Power Mode)
7. GND – Ground Pin
8. RESET – Target MCU Reset Signal
9. CNVss – Target MCU CNVss Pin
10. TXD – Target MCU Transmit Data Output Signal (ICD Receive Data Input
Signal)
10 / 27
Applications Engineering
Jan 2005