HS2339KCM01H Renesas Electronics America, HS2339KCM01H Datasheet - Page 154

• Manufacturer Part Number: HS2339KCM01H
• Description: ON CHIP DEBUG EMULATOR
• Manufacturer: Renesas Electronics America

Specifications of HS2339KCM01H

• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

6.5.3
1. When an odd address is set, the address is rounded down to an even address.
2. A software break is accomplished by replacing instructions. Accordingly, it can be set only to
3. During step execution, a software breakpoint is disabled.
4. A condition set at Break Condition is disabled immediately after starting execution when an
5. When execution resumes from the breakpoint address after the program execution stops at the
6.
6.5.4
When the JTAG clock (TCK) is used, set the frequency to lower than that of the system clock.
6.5.5
128
the flash memory or the RAM area. However, a software break cannot be set to the following
addresses:
instruction at a software breakpoint is executed. A break does not occur even if a condition of
Break Condition is satisfied immediately after starting the execution.
software breakpoint, single-step execution is performed at the address before execution
resumes. Therefore, realtime operation cannot be performed.
The trace function in the H8S/2339F E10A emulator uses the branch-instruction trace function
in the MCU. It displays the branch-source address or the mnemonic, and operand can be
acquired in realtime.
Settings of software breakpoint and Break Condition are invalid while the STEP OVER
function is being used.
An area other than flash memory or RAM
An instruction in which Break Condition is satisfied
Notes on Setting the [Breakpoint] Dialog Box
Note on Using the JTAG Clock (TCK)
Trace Function