SW500007 Microchip Technology, SW500007 Datasheet - Page 409

• Manufacturer Part Number: SW500007
• Description: PICC-18 PRO
• Manufacturer: Microchip Technology
• Type: Compilerr
• Series: PIC18r

Specifications of SW500007

• Supported Families: PIC18
• Core Architecture: PIC
• Software Edition: Professional
• Kit Contents: Software And Docs
• Mcu Supported Families: PIC18
• Tool Function: Compiler
• Tool Type: Compiler
• Lead Free Status / RoHS Status: Not applicable / RoHS Compliant
• For Use With/related Products: PIC18 Series
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 015P; 778-1002; 778-1002

Error and Warning Messages
(1202) unknown format requested in -FORMAT: *
An unknown or unsupported INHX format has been requested. Refer to documentation for supported
INHX formats.
(1203) unpaired nibble in * value will be truncated
Data to this option was not entered as whole bytes. Perhaps the data was incomplete or a leading
zero was omitted. For example the value Fh contains only four bits of significant data and is not a
whole byte. The value 0Fh contains eight bits of significant data and is a whole byte.
(1204) * value must be between 1 and * bytes long
An illegal legth of data was given to this option. The value provided to this option exceeds the
maximum or minimum bounds required by this option.
(1212) Found * (*h) at address *h
The code sequence specified in a -FIND option has been found at this address.
ambiguous chip type * -> * or *
The chip type specified on the command line is not complete and could refer to more than one chip.
Specify the full name of the chip type.
a maximum of * reserved areas are allowed. remainder of -RES* ignored
Too many address ranges were specified with either the -RESROM or -RESRAM option.
can’t create cross reference file *
The assembler attempted to create a cross reference file, but it could not be created. Check that the
file’s pathname is correct.
couldn’t create error file: *
The error file specified after the -Efile or -E+file options could not be opened. Check to ensure
that the file or directory is valid and that has read only access.
(Assembler)
(Hexmate)
(Hexmate)
(Hexmate)
(Hexmate)
(Driver)
(Driver)
(Driver)
395