FS2003-UPG15 Equinox Technologies, FS2003-UPG15 Datasheet - Page 21

• Manufacturer Part Number: FS2003-UPG15
• Description: UPGRADE FS2003 ATMEL AT91SAM7
• Manufacturer: Equinox Technologies
• Type: Upgrade Kitr

Specifications of FS2003-UPG15

• For Use With/related Products: FS2003
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Key:
S – Device supported as standard
U – Chargeable license upgrade required
* – Support to be announced – please contact Equinox for a Support Date
For an up-to-date Device Support list, please refer to the ‘Device Support’ section for this programmer
on the Equinox Website.
Important note:
Please refer to the relevant Application Note for details of how to connect the programmer to the
Target Device on the Target System. The Application Notes can be found on the FS2003 -
Download Page on the Equinox website.
1.5.2 Programming Interface to Target Device
#
1
2
3
4
Please note:
A chargeable license upgrade is required to enable the ATmega JTAG ISP libraries.
18
Programming
Interface
LV SPI
HV SPI (+12V
Vpp)
UART Boot
Loader
JTAG
(Atmel AVR)
The programmer supports the following programming interfaces to the Target Device:
Family
AT89S
AT90S
AT90USB
AT90CAN
ATmega
ATtiny
Zensys
ATtiny
T89C51Rx2
P89X51Rx2
ATmega
AT90USB
AT90CAN
Description / Comment
Atmel Low Voltage Serial Programming Mode
Atmel High Voltage Serial Programming Mode
Atmel / Philips UART Boot Loader Interface
Atmel ATmega AVR – JTAG ISP Interface
•
•
•
•
•
•
•
•
•
•
•
Atmel 3-wire SPI interface (SCK, MOSI, MISO )
Target Device RESET
Works at target voltage (no Vpp required)
Atmel 4-wire SPI Interface (SCK, MOSI, MISO, MOSI2)
+12V Vpp is applied to the RESET pin to enter High
Voltage Serial Programming Mode
Requires different connections to Target Device
compared with LV SPI.
Requires all pins of target device to be accessible by the
programmer.
Uses RXD, TXD, PSEN, and Target Device RESET pin
TTL Levels from programmer to Target System
Uses same connector as Atmel JTAG ICE
A chargeable license upgrade is required to enable the
ATmega JTAG ISP libraries.
FS2003 ISP Programmer - User Guide V1.08 – 1
st
August 2008