FS-929 Digi International, FS-929 Datasheet - Page 37

• Manufacturer Part Number: FS-929
• Description: JTAG-BOOSTER FOR SA-11X0 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-929

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: Intel StrongARM SA-11x0, 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2.2.
Usage:
The contents of a flash device is read and written to a file.
The type of flash device is normally detected by the software. When autodetect
fails you should use the /DEVICE= option together with /8BIT or /16BIT or
/32BIT to set the right flash device and configuration. The known devices are
shown in chapter 1.10 “Supported flash devices”.
Options:
/DEVICE=devicename
See function /P (Chapter 2.1)
/8BIT /16BIT /32BIT
See function /P (Chapter 2.1)
/BYTE-MODE
See function /P (Chapter 2.1)
/NOMAN
See function /P (Chapter 2.1)
/DEVICE-BASE=hhhhhh
See function /P (Chapter 2.1)
/OFFSET=hhhhhh
Reading of the flash memory starts at an offset of hhhhhh relative to the start
address of the flash device. If the offset is negative, the offset specifies a
address relative to the end of the flash device.
See also option /TOP.
Default:
Abbreviation:
2
JTAG_SA11x0b.doc
hhhhhh=number base is hex
Read a Flash Device to file
JTAG11x0 /R filename [optionlist]
/OFFSET=0
/O=
2
37