FS-9005 Digi International, FS-9005 Datasheet - Page 16

• Manufacturer Part Number: FS-9005
• Description: JTAG-BOOSTER FOR ARM7TDMI 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-9005

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: ARM7TDMI, 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

JTAG-Booster for ARM7TDMI
missing filename
Most functions need a filename as second parameter.
missing option /LENGTH=
Some functions need the option /LENGTH= to be defined.
Missing parameter
There is a syntax error in the configuration file. Please check your
configuration file. (See chapter 1.8 “Configuration file JTAGARM7.CFG”
More than 9 devices in the JTAG chain or TDI pin stuck at low level
The JTAG chain is limited to 9 parts. Check target power. Check the target’s
TDO pin.
No devices found in JTAG chain or TDI pin stuck at high level
A stream of 32 high bits was detected on the pin TDI. TDI may stuck at high
level. Check the connection to your target. Check the target power. Check
the target’s TDO pin. Check the target's reset status.
Option /CPUPOS= out of range
The number specified with the option /CPUPOS= must be less or equal to
the number of parts minus 1.
Option /IROFFS= out of range
Please specify a smaller value
Part at specified position is not a ARM7TDMI
The option /CPUPOS= points to a part not a ARM7TDMI
Specify only one of these options:
Some options are exclusive (i.e. /8BIT and /16BIT). Don't mix them.
Sum of instruction register bits to low. Should be at least 4 bits for a
ARM7TDMI
The sum of all instruction register bits in the JTAG chain does not fit to the
ARM7TDMI. Check the target connection. Check the target CPU type. Check
the settings for /IROFFS= and /CPUPOS= , if there are several parts in
the JTAG chain.
16
JTAG_ARM7TDMIa.doc