FS-9005 Digi International, FS-9005 Datasheet - Page 17

• Manufacturer Part Number: FS-9005
• Description: JTAG-BOOSTER FOR ARM7TDMI 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-9005

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: ARM7TDMI, 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

JTAG-Booster for ARM7TDMI
Target is in Thumb mode. Not supported.
Thumb mode is actually not supported. If the target runs in thump mode, the
target can not be stopped.
Target no longer connected
There is a cyclic check of the JTAG chain. Check target power. Check target
connection.
Target out of Sync. Try again
During flash programming the communication between host and target has
broken. This may be a result of using the option /FAST or /FAST=. Please
omit this options or increase the value of the option /FAST=. Another reason
could be an unreliable target RAM. To overcome this problem you may
specify the option /NORAM to avoid using the target's RAM. The
programming performance is reduced dramatically in this case.
Tests Aborted
During loading the configuration file (specified by the option /CFG= or the
file JTAGARM7.CFG) there was an error condition (a line with the command
MEM_TESTxx"). The succeeding line with the command TEST_STOP,
forces a program abort.
There are unknown parts in the JTAG chain. Please use the option
/IROFFS= to specify the instr. reg. offset of the CPU.
If there are unknown parts in the JTAG chain, the program isn’t able to
determine the logical position of the CPU’s instruction register.
There is no ARM7TDMI in the JTAG chain
No ARM7TDMI was found in the JTAG chain. Check the target power. Try
with option /DRIVER=4 again.
Value of option /FILE-OFFSET out of range
The value of the option /FILE-OFFSET= points behind end of file.
wrong driver #
The value specified with the option /DRIVER= is out of range.
JTAG_ARM7TDMIa.doc
17