PIC12C671-10/P Microchip Technology, PIC12C671-10/P Datasheet - Page 659

• Manufacturer Part Number: PIC12C671-10/P
• Description: IC MCU OTP 1KX14 A/D 8DIP
• Manufacturer: Microchip Technology
• Series: PIC® 12Cr

Specifications of PIC12C671-10/P

• Core Size: 8-Bit
• Program Memory Size: 1.75KB (1K x 14)
• Core Processor: PIC
• Speed: 10MHz
• Peripherals: POR, WDT
• Number Of I /o: 5
• Program Memory Type: OTP
• Ram Size: 128 x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 4x8b
• Oscillator Type: Internal
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 8-DIP (0.300", 7.62mm)
• Controller Family/series: PIC12
• No. Of I/o's: 6
• Ram Memory Size: 128Byte
• Cpu Speed: 10MHz
• No. Of Timers: 1
• Digital Ic Case Style: DIP
• Package: 8PDIP
• Device Core: PIC
• Family Name: PIC12
• Maximum Speed: 10 MHz
• Operating Supply Voltage: 3.3|5 V
• Data Bus Width: 8 Bit
• Number Of Programmable I/os: 5
• On-chip Adc: 4-chx8-bit
• Number Of Timers: 1
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: ISPICR1 - ADAPTER IN-CIRCUIT PROGRAMMINGAC124001 - MODULE SKT PROMATEII 8DIP/SOIC
• Eeprom Size: -
• Connectivity: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Transfer direction of data and acknowledgment bits depends on R/W bits.
Sr
Combined format - A master addresses a slave with a 10-bit address, then transmits
1997 Microchip Technology Inc.
Combined format:
S
(Code + A9:A8)
Slave Address
From slave to master
From master to slave
Slave Address R/W A Data A/A Sr
(write)
(read)
R/W A
data to this slave and reads data from this slave.
When a master does not wish to relinquish the bus (which occurs by generating a STOP condi-
tion), a repeated START condition (Sr) must be generated. This condition is identical to the start
condition (SDA goes high-to-low while SCL is high), but occurs after a data transfer acknowledge
pulse (not the bus-free state). This allows a master to send “commands” to the slave and then
receive the requested information or to address a different slave device. This sequence is shown
in
Figure A-8:
Figure
Slave Address
A = acknowledge (SDA low)
A = not acknowledge (SDA high)
S = Start Condition
P = Stop Condition
(A7:A0)
A-8.
Sr = repeated
Start Condition
(n bytes + acknowledge)
(read or write)
Combined Format
Slave Address R/W A Data A/A
A
Data
A
(write)
Data A/A
Direction of transfer
may change at this point
Sr Slave Address
(Code + A9:A8)
P
(read)
Appendix A
R/W A Data A
DS31034A-page 34-7
Data
A P
34