PIC16F1937-I/P Microchip Technology, PIC16F1937-I/P Datasheet
PIC16F1937-I/P
Specifications of PIC16F1937-I/P
Available stocks
Related parts for PIC16F1937-I/P
PIC16F1937-I/P Summary of contents
Page 1
... PIC16LF1934 10 0100 010x xxxx PIC16F1936 10 0011 011x xxxx PIC16LF1936 10 0100 011x xxxx PIC16F1937 10 0011 100x xxxx PIC16LF1937 10 0100 100x xxxx Note 1: The Device ID is located in the last configuration memory space. 2: Refer to the “PIC16F193X/LF193X and PIC16F194X/LF194X Memory Programming Specification” ...
Page 2
... HS Oscillator min 7.1 PWM 0% Duty Cycle Direction Change. 7.2 PWM 0% Duty Cycle Port Steering. 8.1 Toggle Mode works Improperly. 8.2 T1 Gate Flip-Flop does not clear. 9.1 Minimum operating V for the DD PIC16F193X devices (1) Affected Revisions > 85°C. 2010 Microchip Technology Inc. ...
Page 3
... DD Work around Use an error correction method that stores data in multiple locations. Affected Silicon Revisions 2010 Microchip Technology Inc. 2.2 Program Flash Memory writes at Min. V The minimum voltage required for a PFM write operation is 2.0V. Work around None. Affected Silicon Revisions ...
Page 4
... Affected Silicon Revisions DS80479F-page 4 4. Module: Brown-Out Reset (BOR) 4.1 Brown-Out Threshold Configuring the BOR for 2.5V operation, the reset will typically occur at 2.7V. Work around None Affected Silicon Revisions A2 X OSC time earlier than = 2010 Microchip Technology Inc. ...
Page 5
... Each T cycle consists periods. A fixed delay is CY provided to stop the A/D conversion after 86 instruction cycles and terminate the conversion at the correct time as shown in the figure above. 2010 Microchip Technology Inc. Method 3: This method is provided if the , as OSC ADC FRC CY ...
Page 6
... STRxSYNC bit is set, writing the STRxA, STRxB, STRxC and the STRxD bits to enable/ disable steering to port pins has no effect on the outputs. Work around Increase the duty cycle to a value greater than 0% before enabling/disabling steering to port pins. Affected Silicon Revisions PWM (ECCP 2010 Microchip Technology Inc. ...
Page 7
... Clear the T1GTM bit in the T1GCON register to clear and hold clear the output value of the flip- flop. Affected Silicon Revisions 2010 Microchip Technology Inc. 9. Module: LDO 9.1 Minimum V above 85°C DD The minimum voltage required PIC16F193X devices is 3.5 volts for temperatures above 85°C. Note: ...
Page 8
... V must be capacitively decoupled as close to the device 2010 Microchip Technology Inc. Conditions 0°C T +60°C, V 2. 60°C T 85°C, V 2. -40°C T +125°C A 0°C T ...
Page 9
... FIGURE 29-3: HFINTOSC FREQUENCY ACCURACY OVER DEVICE V 125 -20 -40 1.8 2.0 2.5 2010 Microchip Technology Inc. is equal to, DD ± 5% ± 3.0% ± 2% ± 5% 3.0 3.5 4.0 V (V) DD AND TEMPERATURE DD 4 ...
Page 10
... Rev C Document (5/2010) Added Modules and 8. Data Sheet Clarifications: Added Modules 1 and 2. Rev D Document (6/2010) Added Silicon Revision A6. Rev E Document (7/2010) Revised Module 5.1; Added Module 8.2; Other minor corrections. Rev F Document (9/2010) Added Module 9, LDO. DS80479F-page 10 2010 Microchip Technology Inc. ...
Page 11
... PICtail, REAL ICE, rfLAB, Select Mode, Total Endurance, TSHARC, UniWinDriver, WiperLock and ZENA are trademarks of Microchip Technology Incorporated in the U.S.A. and other countries. SQTP is a service mark of Microchip Technology Incorporated in the U.S.A. All other trademarks mentioned herein are property of their respective companies. ...
Page 12
... Philippines - Manila Tel: 63-2-634-9065 Fax: 63-2-634-9069 Singapore Tel: 65-6334-8870 Fax: 65-6334-8850 Taiwan - Hsin Chu Tel: 886-3-6578-300 Fax: 886-3-6578-370 Taiwan - Kaohsiung Tel: 886-7-213-7830 Fax: 886-7-330-9305 Taiwan - Taipei Tel: 886-2-2500-6610 Fax: 886-2-2508-0102 Thailand - Bangkok Tel: 66-2-694-1351 Fax: 66-2-694-1350 2010 Microchip Technology Inc. 08/04/10 ...