AT89C5131A-PLTUL Atmel, AT89C5131A-PLTUL Datasheet - Page 13

• Manufacturer Part Number: AT89C5131A-PLTUL
• Description: IC MCU 32KB 3-3.6V USB 48-VQFN
• Manufacturer: Atmel
• Series: AT89C513xr

Specifications of AT89C5131A-PLTUL

• Core Processor: C52X2
• Core Size: 8-Bit
• Speed: 48MHz
• Connectivity: I²C, SPI, UART/USART, USB
• Peripherals: LED, POR, PWM, WDT
• Number Of I /o: 34
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 4K x 8
• Ram Size: 1.25K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 48-VQFN Exposed Pad, 48-HVQFN, 48-SQFN, 48-DHVQFN
• For Use With: AT89STK-10 - KIT EVAL APPL MASS STORAGEAT89STK-05 - KIT STARTER FOR AT89C5131
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Data Converters: -

Clock Controller
Introduction
Figure 7. Oscillator Block Diagram
Oscillator
4338F–USB–08/07
X1
X2
PLLCON.2
EXT48
PCON.1
PD
The AT89C5131A-L clock controller is based on an on-chip oscillator feeding an on-chip
Phase Lock Loop (PLL). All the internal clocks to the peripherals and CPU core are gen-
erated by this controller.
The AT89C5131A-L X1 and X2 pins are the input and the output of a single-stage on-
chip inverter (see Figure 7) that can be configured with off-chip components as a Pierce
oscillator (see Figure 8). Value of capacitors and crystal characteristics are detailed in
the section “DC Characteristics”.
The X1 pin can also be used as input for an external 48 MHz clock.
The clock controller outputs three different clocks as shown in Figure 7:
•
•
•
These clocks are enabled or disabled depending on the power reduction mode as
detailed in Section “Power Management”, page 152.
Two clock sources are available for CPU:
•
•
In order to optimize the power consumption, the oscillator inverter is inactive when the
PLL output is not selected for the USB device.
a clock for the CPU core
a clock for the peripherals which is used to generate the Timers, PCA, WD, and Port
sampling clocks
a clock for the USB controller
Crystal oscillator on X1 and X2 pins: Up to 32 MHz
External 48 MHz clock on X1 pin
PLL
0
1
÷
2
CKCON.0
X2
0
1
PCON.0
IDL
USB
Clock
Peripheral
Clock
CPU Core
Clock
13