DS5000T-32-16 Maxim Integrated Products, DS5000T-32-16 Datasheet - Page 6

• Manufacturer Part Number: DS5000T-32-16
• Description: IC MPU W/RTC 32KB 16MHZ 40-DIP
• Manufacturer: Maxim Integrated Products
• Series: DS500xr

Specifications of DS5000T-32-16

• Core Processor: 8051
• Core Size: 8-Bit
• Speed: 16MHz
• Connectivity: SIO, UART/USART
• Peripherals: Power-Fail Reset, WDT
• Number Of I /o: 32
• Program Memory Type: SRAM
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 4.75 V ~ 5.25 V
• Oscillator Type: External
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 40-DIP Module (600 mil), 40-EDIP
• Processor Series: DS5000T
• Core: 8051
• Data Bus Width: 8 bit
• Program Memory Size: 32 KB
• Data Ram Size: 32 KB
• Interface Type: 3-Wire, RS-232, UART
• Maximum Clock Frequency: 16 MHz
• Number Of Programmable I/os: 32
• Number Of Timers: 2
• Operating Supply Voltage: 4.75 V to 5.25 V
• Maximum Operating Temperature: + 70 C
• Mounting Style: Through Hole
• 3rd Party Development Tools: PK51, CA51, A51, ULINK2
• Development Tools By Supplier: DS5000TK
• Minimum Operating Temperature: 0 C
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -
• Data Converters: -
• Other names: DS5000T3216

DS5000(T)
PROGRAM LOADING CONFIGURATIONS Figure 3
Table 1 summarizes the selection of the available Parallel Program Load cycles. The timing associated
with these cycles is illustrated in the electrical specs.
SERIAL BOOTSTRAP LOADER
The Serial Program Load Mode is the easiest, fastest, most reliable, and most complete method of
initially loading application software into the DS5000(T) nonvolatile RAM. Communication can be
performed over a standard asynchronous serial communications port. A typical application would use a
simple RS232C serial interface to program the DS5000(T) as a final production procedure. The hardware
configuration required for the Serial Program Load mode is illustrated in Figure 3. Port pins 2.7 and 2.6
must be either open or pulled high to avoid placing the DS5000(T) in a parallel load cycle. Although an
11.0592 MHz crystal is shown in Figure 3, a variety of crystal frequencies and loader baud rates are
supported, shown in Table 2. The serial loader is designed to operate across a 3-wire interface from a
standard UART. The receive, transmit, and ground wires are all that are necessary to establish
communication with the DS5000(T).
The Serial Bootstrap Loader implements an easy-to-use command line interface that allows an application
program in an Intel hex representation to be loaded into and read back from the device. Intel hex is the
typical format which existing 8051 cross-assemblers output.
The serial loader responds to single
character commands, which are summarized below:
6 of 19