HD64F3694H Renesas Electronics America, HD64F3694H Datasheet - Page 311

• Manufacturer Part Number: HD64F3694H
• Description: IC H8 MCU FLASH 32K 64QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300H Tinyr

Specifications of HD64F3694H

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: I²C, SCI
• Peripherals: PWM, WDT
• Number Of I /o: 29
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 64-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

17.4.4
A low-to-high transition of the SDA input with the SCL input high is needed to generate the stop
condition for stopping read, write operation.
The standby operation starts after a read sequence by a stop condition. In the case of write
operation, a stop condition terminates the write data inputs and place the device in an internally-
timed write cycle to the memories. After the internally-timed write cycle (t
as t
17.4.5
All address data and serial data such as read data and write data are transmitted to and from in 8-
bit unit. The acknowledgement is the signal that indicates that this 8-bit data is normally
transmitted to and from.
In the write operation, EEPROM sends "0" to acknowledge in the ninth cycle after receiving the
data. In the read operation, EEPROM sends a read data following the acknowledgement after
receiving the data. After sending read data, the EEPROM enters the bus open state. If the
EEPROM receives "0" as an acknowledgement, it sends read data of the next address. If the
EEPROM does not receive acknowledgement "0" and receives a following stop condition, it stops
the read operation and enters a standby mode. If the EEPROM receives neither acknowledgement
"0" nor a stop condition, the EEPROM keeps bus open without sending read data.
17.4.6
The EEPROM device receives a 7-bit slave address and a 1-bit R/W code following the generation
of the start conditions. The EEPROM enables the chip for a read or a write operation with this
operation.
The slave address consists of a former 4-bit device code and latter 3-bit slave address as shown in
table 17.2. The device code is used to distinguish device type and this LSI uses "1010" fixed code
in the same manner as in a general-purpose EEPROM. The slave address code selects one device
out of all devices with device code 1010 (8 devices in maximum) which are connected to the I
bus. This means that the device is selected if the inputted slave address code received in the order
of A2, A1, A0 is equal to the corresponding slave address reference register (ESAR).
The slave address code is stored in the address H'FF09 in the EEPROM. It is transferred to ESAR
from the slave address register in the memory array during 10 ms after the reset is released. An
access to the EEPROM is not allowed during transfer.
WC
, the device enters a standby mode.
Stop Condition
Acknowledge
Slave Addressing
Rev.5.00 Nov. 02, 2005 Page 281 of 418
WC
) which is specified
Section 17 EEPROM
REJ09B0028-0500
2
C