R5F21217JFP#U0 Renesas Electronics America, R5F21217JFP#U0 Datasheet - Page 79

• Manufacturer Part Number: R5F21217JFP#U0
• Description: IC R8C/20 MCU FLASH 48LQFP
• Manufacturer: Renesas Electronics America
• Series: R8C/2x/21r

Specifications of R5F21217JFP#U0

• Core Processor: R8C
• Core Size: 16/32-Bit
• Speed: 20MHz
• Connectivity: I²C, LIN, SIO, SSU, UART/USART
• Peripherals: POR, Voltage Detect, WDT
• Number Of I /o: 41
• Program Memory Size: 48KB (48K x 8)
• Program Memory Type: FLASH
• Ram Size: 2.5K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 12x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 48-LQFP
• For Use With: R0E521237CPE00 - EMULATOR COMPACT R8C/20/21/22/23
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

R8C/20 Group, R8C/21 Group
Rev.2.00 Aug 27, 2008
REJ09B0250-0200
7.5
Figure 7.13
Table 7.48
NOTES:
Ports P0 to P2, P3_0,
P3_1, P3_3 to P3_7,
P4_3 to P4_5, P6
Ports P4_6, P4_7
Port P4_2/VREF
RESET
Table 7.48 lists Unassigned Pin Handling.
1. If these ports are set to output mode and left open, they remain input mode until they are switched to
2. Connect these unassigned pins to the MCU using the shortest wire length (2 cm or less) as
3. When power-on reset function is in use.
output mode by a program. The voltage level of these pins may be undefined and the power current
may increase while the ports remain input mode.
The content of the direction registers may change due to noise or program runaway caused by
noise. In order to enhance program reliability, the program should periodically repeat the setting of
the direction registers.
possible.
Unassigned Pin Handling
(3)
Pin Name
Unassigned Pin Handling
Unassigned Pin Handling
Page 61 of 458
NOTE:
• After setting to input mode, connect every pin to VSS via a resistor (pull-
• After setting to output mode, leave these pins open.
Connect to VCC via a resistor (pull-up)
Connect to VCC
Connect to VCC via a resistor (pull-up)
down) or connect every pin to VCC via a resistor (pull-up).
P3_1, P3_3 to P3_7,
1. When power-on reset function is in use.
Port P0 to P2, P3_0,
P4_3 to P4_5, P6
MCU
Port P4_6, P4_7
Port P4_2/VREF
(Output mode)
(Input mode )
(Input mode)
RESET
:
:
(1)
Connection
Open
:
:
(2)
(2)
7. Programmable I/O Ports
(1, 2)
(2)