AD548KNZ Analog Devices Inc, AD548KNZ Datasheet - Page 10

• Manufacturer Part Number: AD548KNZ
• Description: IC OPAMP GP 1MHZ LP PREC 8DIP
• Manufacturer: Analog Devices Inc
• Type: General Purpose Amplifierr

Specifications of AD548KNZ

• Slew Rate: 1.8 V/µs
• Amplifier Type: General Purpose
• Number Of Circuits: 1
• Gain Bandwidth Product: 1MHz
• Current - Input Bias: 30pA
• Voltage - Input Offset: 300µV
• Current - Supply: 170µA
• Current - Output / Channel: 15mA
• Voltage - Supply, Single/dual (±): ±4.5 V ~ 18 V
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Through Hole
• Package / Case: 8-DIP (0.300", 7.62mm)
• Op Amp Type: Precision
• No. Of Amplifiers: 1
• Bandwidth: 1MHz
• Supply Voltage Range: ± 4.5V To ± 18V
• Amplifier Case Style: DIP
• No. Of Pins: 8
• Operating Temperature Range: 0°C To +70°C
• Rail/rail I/o Type: No
• Number Of Elements: 1
• Unity Gain Bandwidth Product: 1MHz
• Common Mode Rejection Ratio: 76dB
• Input Offset Voltage: 500uV
• Input Bias Current: 15pA
• Single Supply Voltage (typ): Not RequiredV
• Dual Supply Voltage (typ): ±5/±9/±12/±15V
• Power Dissipation: 500mW
• Voltage Gain In Db: 116.9dB
• Power Supply Requirement: Dual
• Shut Down Feature: No
• Single Supply Voltage (min): Not RequiredV
• Single Supply Voltage (max): Not RequiredV
• Dual Supply Voltage (min): ±4.5V
• Dual Supply Voltage (max): ±18V
• Technology: BiFET
• Operating Temp Range: 0C to 70C
• Operating Temperature Classification: Commercial
• Mounting: Through Hole
• Pin Count: 8
• Package Type: PDIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Output Type: -
• -3db Bandwidth: -
• Lead Free Status / Rohs Status: Compliant

AD548
compensation is provided by resistors R8 and R15 that have a
positive 3500 ppm/°C temperature coefficient. The transfer
function for the output voltage is:
= 1V log
V
(I
/ I
)
OUT
10
2
1
Frequency compensation is provided by R11, R12, C1, and C2.
Small signal bandwidth is approximately 300 kHz at input cur-
rents above 100 µA and will proportionally decrease with lower
signal levels. D1, D2, R13, and R14 compensate for the effects
of the two logging transistors’ ohmic emitter resistance.
To trim this circuit, set the two input currents to 10 µA and adjust
V
to zero by adjusting the potentiometer on A3. Then set I
OUT
2
to 1 µA and adjust the scale factor such that the output voltage is
1 V by trimming potentiometer R10. Offset adjustment for A1 and
A2 is provided to increase the accuracy of the voltage inputs.
This circuit ensures a 1% log conformance error over an input
current range of 300 pA to 1 mA, with low level accuracy
limited by the AD548’s input current. The low level input voltage
accuracy of this circuit is limited by the input offset voltage and
drift of the AD548.
Figure 10. Log Ratio Amplifier
–10–
REV. D