LP2982IM5X-3.0/NOPB National Semiconductor, LP2982IM5X-3.0/NOPB Datasheet - Page 12

• Manufacturer Part Number: LP2982IM5X-3.0/NOPB
• Description: IC REG LDO MICROPOWER SOT23-5
• Manufacturer: National Semiconductor

Specifications of LP2982IM5X-3.0/NOPB

• Regulator Topology: Positive Fixed
• Voltage - Output: 3V
• Voltage - Input: Up to 16V
• Voltage - Dropout (typical): 0.12V @ 50mA
• Number Of Regulators: 1
• Current - Output: 50mA
• Current - Limit (min): 100mA
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: SOT-23-5, SC-74A, SOT-25
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: *LP2982IM5X-3.0; *LP2982IM5X-3.0/NOPB; LP2982IM5X-3.0

www.national.com
REVERSE CURRENT PATH
The internal PNP power transistor used as the pass element
in the LP2982 has an inherent diode connected between the
regulator output and input. During normal operation (where
the input voltage is higher than the output) this diode is re-
verse biased (See Figure 3).
However, if the input voltage is more than a V
output voltage, this diode will turn ON and current will flow into
the regulator output. In such cases, a parasitic SCR can latch
which will allow a high current to flow into the V
the ground pin, which can damage the part.
The internal diode can also be turned on if the input voltage
is abruptly stepped down to a voltage which is a V
the output voltage.
In any application where the output voltage may be higher
than the input voltage, an external Schottky diode must be
connected from V
V
LP2982 to 0.3V (see Absolute Maximum Ratings).
FIGURE 4. Adding External Schottky Diode Protection
OUT
. See Figure 4), to limit the reverse voltage across the
FIGURE 3. LP2982 Reverse Current Path
IN
to V
OUT
(cathode on V
IN
IN
BE
, anode on
1267939
1267940
pin and out
below the
BE
below
12
ON/OFF INPUT OPERATION
The LP2982 is shut off by pulling the ON/OFF input low, and
turned on by driving the input high. If this feature is not to be
used, the ON/OFF input should be tied to V
ulator on at all times (the ON/OFF input must not be left
floating).
To ensure proper operation, the signal source used to drive
the ON/OFF input must be able to swing above and below the
specified turn-on/turn-off voltage thresholds which guarantee
an ON or OFF state (see Electrical Characteristics).
The ON/OFF signal may come from either a totem-pole out-
put, or an open-collector output with pull-up resistor to the
LP2982 input voltage or another logic supply. The high-level
voltage may exceed the LP2982 input voltage, but must re-
main within the Absolute Maximum Ratings for the ON/OFF
pin.
It is also important that the turn-on/turn-off voltage signals
applied to the ON/OFF input have a slew rate which is greater
than 40 mV/μs.
IMPORTANT: the regulator shutdown function will not oper-
ate correctly if a slow-moving signal is applied to the ON/OFF
input.
IN
to keep the reg-