SP232ACN-L Exar Corporation, SP232ACN-L Datasheet - Page 10

• Manufacturer Part Number: SP232ACN-L
• Description: IC DVR/RCVR RS232 LP 16NSOIC
• Manufacturer: Exar Corporation
• Type: Transceiverr

Specifications of SP232ACN-L

• Package / Case: 16-SOIC (0.154", 3.90mm Width)
• Number Of Drivers/receivers: 2/2
• Protocol: RS232
• Voltage - Supply: 4.5 V ~ 5.5 V
• Mounting Type: Surface Mount
• Operating Supply Voltage: 5 V
• Supply Current: 3 mA
• Operating Temperature Range: 0 C to + 70 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 1016-1020-5

Table 2. Transceiver ESD Tolerance Levels
Figure 11. ESD Test Waveform for IEC1000-4-2
discharge current rather than the discharge
voltage. Variables with an air discharge such as
approach speed of the object carrying the ESD
potential to the system and humidity will tend to
change the discharge current. For example, the
rise time of the discharge current varies with the
approach speed.
The Contact Discharge Method applies the ESD
current directly to the EUT. This method was
devised to reduce the unpredictability of the
ESD arc. The discharge current rise time is
constant since the energy is directly transferred
without the air-gap arc. In situations such as
hand held systems, the ESD charge can be directly
Date: 7/19/04
15A
30A
0A
SP202E
Family
Driver Outputs
Receiver Inputs
t=0ns
t
HUMAN BODY
MODEL
±15kV
±15kV
t=30ns
SP202E Series High Performance RS232 Transceivers
Air Discharge
10
±15kV
±15kV
discharged to the equipment from a person already
holding the equipment. The current is transferred
on to the keypad or the serial port of the equipment
directly and then travels through the PCB and
finally to the IC.
The circuit models in Figures 9 and 10 represent
the typical ESD testing circuit used for all three
methods. The C
power supply when the first switch (SW1) is on.
Now that the capacitor is charged, the second
switch (SW2) is on while SW1 switches off. The
voltage stored in the capacitor is then applied
through R
device under test (DUT). In ESD tests, the SW2
switch is pulsed so that the device under test
receives a duration of voltage.
For the Human Body Model, the current limiting
resistor (R
1.5kΩ an 100pF, respectively. For IEC-1000-4-
2, the current limiting resistor (R
capacitor (C
The higher C
IEC1000-4-2 model are more stringent than the
Human Body Model. The larger storage capacitor
injects a higher voltage to the test point when
SW2 is switched on. The lower current limiting
resistor increases the current charge onto the test
point.
S
S
, the current limiting resistor, onto the
Direct Contact
) and the source capacitor (C
S
IEC1000-4-2
) are 330Ω an 150pF, respectively.
S
value and lower R
S
±8kV
±8kV
is initially charged with the DC
© Copyright 2004 Sipex Corporation
S
) and the source
S
value in the
Level
4
4
S
) are