X09-009PKC-RA Digi International/Maxstream, X09-009PKC-RA Datasheet - Page 36

• Manufacturer Part Number: X09-009PKC-RA
• Description: MOD RF 900MHZ 9600BPS RS232/485
• Manufacturer: Digi International/Maxstream
• Series: XStream™r

Specifications of X09-009PKC-RA

• Function: Transceiver, FHSS
• Modulation Or Protocol: FHSS, FSK
• Frequency: 900MHz
• Applications: ISM
• Interface: RS-232, RS-485
• Sensitivity: -110dBm
• Power - Output: 20dBm (100mW)
• Data Rate - Maximum: 10 kbps
• Voltage - Supply: 7 V ~ 18 V
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -

© 2006 MaxStream, Inc. Confidential & Proprietary
XStream‐PKG‐R™ RS‐232/485 RF Modem – Product Manual v5.x00 [2006.02.24]
RS (RSSI) Command
RT (DI2 Configuration) Command
RZ (DI Buffer Size) Command
SB (Stop Bits) Command
SH (Serial Number High) Command
<Diagnostics> RS Command returns the signal
level of the last packet received. This reading is
useful for determining range characteristics of the
XStream Modems under various conditions of
noise and distance.
Once the command is issued, the modem will
return a value between 0x6 and 0x36 where
0x36 represents a very strong signal level and 0x4 indicates a low signal level.
<Serial Interfacing> RT command is used to
dictate the behavior of the DI2/
Command must be issued to enable
control or binary programming.
<Diagnostics> The RZ command is used to read
the size of the DI buffer (UART RX (Receive)).
Note: The DO buffer size can be determined by
multiplying the DI buffer size by 1.5.
<Serial Interfacing> SB Command is used to
set/read the number of stop bits in the data
packets.
<Diagnostics> Set/Read the serial number high
word of the modem.
/CMD line. RT
flow
AT Command: ATRZ
Binary Command: 0x2C (44 decimal)
Parameter Range: Read-only
Number of bytes returned: 2
Minimum Firmware Version Required: 4.30
AT Command: ATRS
Binary Command: 0x1C (28 decimal)
Parameter Range: 0x06 – 0x36 [Read-only]
Number of bytes returned: 1
Minimum Firmware Version Required: 4.22
AT Command: ATRT
Binary Command: 0x16 (22 decimal)
Parameter Range: 0 – 2
Default Parameter Value: 0
Number of bytes returned: 1
AT Command: ATSB
Binary Command: 0x36 (54 decimal)
Parameter Range: 0 – 1
Default Parameter Value: 0
Number of bytes returned: 1
Minimum Firmware Version Required: 4.2B
AT Command: ATSH
Binary Command: 0x25 (37 decimal)
Parameter Range: 0 – 0xFFFF [Read-only]
Number of bytes returned: 2
Related Commands: SL (Serial Number Low)
Minimum Firmware Version Required: 4.27C
Parameter
Parameter
0
1
2
0
1
Enable Binary Programming
Enable
Configuration
Configuration
1 stop bits
2 stop bits
disabled
Flow Control
36