XT09-PKT-RA-NA Digi International/Maxstream, XT09-PKT-RA-NA Datasheet - Page 29

• Manufacturer Part Number: XT09-PKT-RA-NA
• Description: MODEM RF 900MHZ RS232/485 INT
• Manufacturer: Digi International/Maxstream
• Series: XTend™r

Specifications of XT09-PKT-RA-NA

• Function: Transceiver, Modem
• Frequency: 900MHz
• Interface: RS-232
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Power - Output: -
• Applications: -
• Sensitivity: -
• Data Rate - Maximum: -
• Modulation Or Protocol: -

9XTend™ RS‐232/485 RF Modem ‐ Product Manual v2.x4x [2007.01.04]
BT (Guard Time Before) Command
CC (Command Sequence Character) Command
CD (GPO2 Configuration) Command
CF (Number Base) Command
<AT Command Mode Options> The CC command
is used to set/read the ASCII character used
between guard times of the AT Command Mode
Sequence (BT + CC + AT). This sequence enters
the modem into AT Command Mode so that data
entering the modem (from the host) is recognized
as commands instead of payload.
<AT Command Mode Options> The CC command
is used to set/read the ASCII character used
between guard times of the AT Command Mode
Sequence (BT + CC + AT). This sequence enters
the modem into AT Command Mode so that data
entering the modem (from the host) is recognized
as commands instead of payload.
<Serial Interfacing> CD Command is used to
select/read the behavior of the GPO2 line (pin 3).
<Command Mode Options> CF command is used
to set/read the command formatting setting.
The following commands are always entered and
read in hex, no matter the CF setting:
© 2007 MaxStream, Inc.
VR (Firmware Version)
HV (Hardware Version)
KY (AES Encryption Key)
AT Command: ATCF
Parameter Range: 0 – 2
Default Parameter Value: 1
Number of bytes returned: 1
AT Command: ATCC
Binary Command: 0x13 (19 decimal)
Parameter Range: 0x20 - 0x7F
Default Parameter Value: 0x2B (ASCII “+”)
Number of bytes returned: 1
Related Commands: AT (Guard Time After), BT
(Guard Time Before)
AT Command: ATCC
Binary Command: 0x13 (19 decimal)
Parameter Range: 0x20 - 0x7F
Default Parameter Value: 0x2B (ASCII “+”)
Number of bytes returned: 1
Related Commands: AT (Guard Time After), BT
(Guard Time Before)
AT Command: ATCD
Binary Command: 0x28 (40 decimal)
Parameter Range: 0 - 8 (standard rates)
Default Parameter Value: 2
Number of bytes returned: 1
Parameter
Parameter
0
1
2
Chapter 4 ‐ RF Modem Configuration
0
1
2
3
4
commands may output units
Commands utilize default
default number base; no
All commands forced to
unsigned, unit-less hex
Commands utilize their
number base; decimal
units are output
Configuration
(valid address only)
Configuration
Default High
Default Low
(reserved)
RX LED
RX LED
29