ATMEGA128RZBV-8AU Atmel, ATMEGA128RZBV-8AU Datasheet - Page 15

• Manufacturer Part Number: ATMEGA128RZBV-8AU
• Description: MCU ATMEGA1280/AT86RF230 100TQFP
• Manufacturer: Atmel
• Series: ATMEGAr

Specifications of ATMEGA128RZBV-8AU

• Frequency: 2.4GHz
• Data Rate - Maximum: 2Mbps
• Modulation Or Protocol: 802.15.4 Zigbee
• Applications: General Purpose
• Power - Output: 3dBm
• Sensitivity: -101dBm
• Voltage - Supply: 1.8 V ~ 3.6 V
• Data Interface: PCB, Surface Mount
• Memory Size: 128kB Flash, 4kB EEPROM, 8kB RAM
• Antenna Connector: PCB, Surface Mount
• Package / Case: 100-TQFP
• Wireless Frequency: 2.4 GHz
• Interface Type: JTAG, SPI
• Output Power: 3 dBm
• For Use With: ATAVRISP2 - PROGRAMMER AVR IN SYSTEMATSTK501 - ADAPTER KIT FOR 64PIN AVR MCUATSTK500 - PROGRAMMER AVR STARTER KIT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Operating Temperature: -
• Current - Transmitting: -
• Current - Receiving: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATmega128

Figure 6-11. Packet Structure - SRAM Write Access
Figure 6-12. Packet Structure - SRAM Read Access
Figure 6-13. Example SPI Sequence – SRAM Write Access Sequence of a 5 byte Data Package
SCLK
MOSI
MISO
5131E-MCU Wireless-02/09
SEL
COMMAND
XX
ADDRESS
The SRAM access mode is useful, for instance, if a transmit frame is already stored in
the Frame Buffer and certain bytes (e.g. sequence number or address field) need to be
replaced before retransmitting the frame. Furthermore, it can be used to access only
the LQI value after frame reception. A detailed description of the user accessible frame
content can be found in section 9.3.2.
Each access starts by setting SEL = L. The first transferred byte on MOSI shall be the
command byte and must indicate a SRAM access mode according to the definition in
Table 6-2. The following byte indicates the start address of the write or read access.
The address space is 0x00 to 0x7F. The microcontroller software has to ensure to
access only to the valid address space.
On SRAM write access, one or more bytes of write data are transferred on MOSI
starting with the third byte of the access sequence (see Figure 6-11).
On SRAM read access, one or more bytes of read data are transferred on MISO
starting with the third byte of the access sequence (see Figure 6-12).
As long as SEL is logic low, every subsequent byte read or write increments the
address counter of the Frame Buffer until the SRAM access is terminated by setting
Figure 6-13 and Figure 6-14 illustrate an example SPI sequence of a SRAM access to
write and read a data package of 5 byte length respectively.
XX
SEL = H.
DATA 1
XX
DATA 2
XX
DATA 3
XX
DATA 4
XX
AT86RF230
DATA 5
XX
15