ATMEGA128RZBV-8AU Atmel, ATMEGA128RZBV-8AU Datasheet - Page 92

• Manufacturer Part Number: ATMEGA128RZBV-8AU
• Description: MCU ATMEGA1280/AT86RF230 100TQFP
• Manufacturer: Atmel
• Series: ATMEGAr

Specifications of ATMEGA128RZBV-8AU

• Frequency: 2.4GHz
• Data Rate - Maximum: 2Mbps
• Modulation Or Protocol: 802.15.4 Zigbee
• Applications: General Purpose
• Power - Output: 3dBm
• Sensitivity: -101dBm
• Voltage - Supply: 1.8 V ~ 3.6 V
• Data Interface: PCB, Surface Mount
• Memory Size: 128kB Flash, 4kB EEPROM, 8kB RAM
• Antenna Connector: PCB, Surface Mount
• Package / Case: 100-TQFP
• Wireless Frequency: 2.4 GHz
• Interface Type: JTAG, SPI
• Output Power: 3 dBm
• For Use With: ATAVRISP2 - PROGRAMMER AVR IN SYSTEMATSTK501 - ADAPTER KIT FOR 64PIN AVR MCUATSTK500 - PROGRAMMER AVR STARTER KIT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Operating Temperature: -
• Current - Transmitting: -
• Current - Receiving: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATmega128

Data Sheet Revision History
Rev. 5131E-ZIGB-02/04/09
Rev. 5131D-ZIGB-12/03/07
Rev. 5131C-ZIGB-05/22/07
Rev. 5131A-ZIGB-06/14/06
92
AT86RF230
1. Removed PRELIMINARY statement
2. Updated parameter 11.4.4
3. Minor editorial changes
The AT86RF230 data sheet was fully revised and modifications of silicon revision
AT86RF230 Rev. B were incorporated. A migration note of silicon revision A to revision
B is available on www.atmel.com.
The most important modifications are:
4. Device version number in register 0x1D (VERSION_NUM) changed to 2 (section 6.3)
5. SPI Interface: MISO pin is updated on falling edge at pin SCLK (section 6.1)
6. Extended Operating Mode state diagram: State changes towards RX_AACK_ON
7. Enhanced return code of TX_ARET transaction in register bits TRAC_STATUS of
8. FCS check of received frames in Basic Operating Mode (section 8.2)
9. Support of pending data indication in Extended Operating Mode (sections 7.2.3.1,
10. Update package drawing (section 16)
1. Major revise of sections 1 to 10
2. Added “Appendix A - Continuous Transmission Test Mode”
3. Added “Appendix B - Errata”
1. Initial release
and TX_ARET_ON (Figure 7-5)
register 0x02 (section 7.2.3.2)
7.2.3.2)
5131E-MCU Wireless-02/09