X09-019NSC-TX Digi International/Maxstream, X09-019NSC-TX Datasheet - Page 53

• Manufacturer Part Number: X09-019NSC-TX
• Description: MOD RF TX 900MHZ 19.2K W/RPSMA
• Manufacturer: Digi International/Maxstream
• Series: XStream™r

Specifications of X09-019NSC-TX

• Frequency: 900MHz
• Data Rate - Maximum: 19.2kbps
• Modulation Or Protocol: FSK
• Power - Output: 100mW
• Sensitivity: -110dBm
• Voltage - Supply: 5V
• Current - Receiving: 50mA
• Current - Transmitting: 140mA
• Data Interface: PCB, Through Hole
• Antenna Connector: RP-SMA
• Operating Temperature: 0°C ~ 70°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Applications: -
• Memory Size: -

Figure B‐01. Front View
Figure B‐02. Back View
Figure B‐03. MaxStream XIB
XStream™ OEM RF Module – Product Manual v5.x00 [2006.02.24]
B‐01a.
Power
Switch
B‐01b.
LEDs
B‐02a.
DIP Switch
B‐01c.
Serial Port
B‐02b.
Config
MaxStream RS-232/485 Interface Board
‐R (RS‐232/485) Interface Board DIP Switch Settings
© 2006 MaxStream, Inc. Confidential and Proprietary
Switch
B‐0d.
Po
Connector
wer
B-01a. Power Switch
B-01b. LEDs
B-01c. Serial Port
B-01d. Power Connector
B-02a. DIP Switch
B-02b. Config (Configuration) Switch
Move the Power Switch to the on (up) position to power the
Interface Board. DIP Switch [B.2a] settings are only read
during a power-up sequence.
The LED indicators visualize diagnostic status information. The
module’s status is represented as follows:
Standard female DB-9 (RS-232) DCE connector – T
can be also used for RS-485 and RS
7-18 VDC Power Connector (Center positive, 5.5/2.1mm) – Power
can also be supplied through Pin 9 of the D
The DIP Switch automatically configures the XStrea
Module to operate in different modes. Each tim
assembly (interface board + the RF Module) is p
intelligence on the XIB-R interface board progra
according to the positions of the DIP Switch. [Se figure below
for DIP Switch settings]
NOTE: In cases where AT Commands should n
the module assembly is powered-on, the processor must be
disabled by populating J7 on the interface board.
The Configuration Switch provides an alternate way to enter “AT
Command Mode”. To enter “AT Command Mode” at the module’s
default baud rate, hold the Configuration Switch down while
powering on the module using the Power Switch [B-01a].
Yellow (top LED) = S
Green (middle) = Serial Data In (from host)
Red (botto
powered, off b
m) = Power/TX Indicator (Red light is on when
riefly during RF transmission)
erial Data Out (to host)
-422 connectio
Refer to table in the
Automatic DIP Switch
Configurations section [next
page] for more information
regarding configurations
triggered by the DIP Switch.
B-9 Serial Port.
ot b
e the module
ms the module
ow
e
ns.
e sent each t
ered-on,
his co
m OEM RF
nnector
53
ime