V2-EVAL-EXT64 FTDI, V2-EVAL-EXT64 Datasheet - Page 29

• Manufacturer Part Number: V2-EVAL-EXT64
• Description: Interface Modules & Development Tools USB V2-EVAL Daughter Module 64-pin
• Manufacturer: FTDI

Specifications of V2-EVAL-EXT64

• Interface Type: USB, Serial, UART, FIFO, SPI
• Data Bus Width: Serial, 8 bit
• Operating Supply Voltage: 4.75 V to 5.25 V
• Product: Interface Modules
• Silicon Manufacturer: FTDI
• Silicon Family Name: Vinculum II
• Features: Embedded USB Host / Slave Chip, Two USB Type A Connectors
• Svhc: No SVHC (18-Jun-2010)
• Rohs Compliant: Yes
• Kit Features: Module With 64-pin QFN VNC2
• For Use With/related Products: VNC2-64
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: V2-EVAL Kit

5.9
JP1 and JP2 jumpers are designed to provide backwards compatibility for VNC1L firmwares migrated to
the VNC2. The jumpers are used select between the UART, FIFO and SPI slave interface for use as the
monitor port on the VNC1L. The jumper configurations for each interface are listed in
details on the monitor port are available in the VNC1L Firmware User Manual (FT_000006).
When not running VNC1L firmwares, jumpers JP1 and JP2 can be used by designers as general purpose
GPIO jumper select inputs to the VNC2.
Jumper
JP1
JP2
Notes:
JP1 (INT_SEL0)
Table 5.13
Table 5.14
(38) To run VNC1L firmwares, jumper JP9 must also be removed.
(39) The use of these pins for GPIO is set by the IOMUX on the VNC2 device. The pins are shared by
Pull-down
Pull-down
Pull-up
Pull-up
Figure 5.14
other connectors on the board. Care should be taken to ensure that pins are not driven from
other headers on the board.
48-PIN
46 / IOBUS25
47 / IOBUS26
VNC1L Interface Mode Select / GPIO Jumpers JP1, JP2
GPIO jumpers JP1, JP2
Monitor Interface Select – VNC1L Firmware Backwards Compatiblity
VNC2 Pin Number / Signal Name
JP2 (INT_SEL1)
GPIO Jumper pins, JP1, JP2
Pull-down
Pull-down
Copyright © 2010 Future Technology Devices International Limited
Pull-up
Pull-up
(38)
64-PIN
29 / IOBUS17
Mode
Serial UART
SPI
FIFO
Serial UART
-
V2-EVAL Vinculum II Evaluation Board Datasheet Version 2.0
VNC2 Signal Name
Comments
INT_SEL0. Signal also connected to LED5
INT_SEL1.
Document Reference No.: FT_000247
Clearance No.: FTDI#148
Table 5.14
. More
28