CB-ACC-53 ConnectBlue, CB-ACC-53 Datasheet - Page 44

• Manufacturer Part Number: CB-ACC-53
• Description: ANTENNA DUAL-BAND RPSMA
• Manufacturer: ConnectBlue

Specifications of CB-ACC-53

• Antenna Type: Whip: 1/2 Wave, Swivel, Tilt (Right Angle)
• Number Of Bands: 2
• Frequency: 2.4GHz, 5GHz
• Gain: 3dBi
• Termination: RP-SMA
• Mounting Type: Connector
• Height (max): 4.21" (107mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 809-1035

7.3.2.3 Labeling Requirements for End Product
For an end product using the product cB-0901-0302 there must be a label containing, at least,
the following information:
The label must be affixed on an exterior surface of the end product such that it will be visible
upon inspection in compliance with the modular approval guidelines developed by the FCC.
In accordance with 47 CFR § 15.19 the end product shall bear the following statement in a
conspicuous location on the device:
“This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.”
When the device is so small or for such use that it is not practicable to place the statement
above on it, the information shall be placed in a prominent location in the instruction manual or
pamphlet supplied to the user or, alternatively, shall be placed on the container in which the
device is marketed. However, the FCC ID label must be displayed on the device.
In case, where the final product will be installed in locations where the end-user
is not able to see the FCC ID and/or this statement, the FCC ID and the statement shall also be
included in the end-product manual.
7.3.2.4 RF-exposure Statement for cB-0901-0302
This modular transmitter MUST have a separation distance of at least 20 cm between the an-
tenna and the body of the user or nearby persons, excluding hands, wrists, feet, and ankles.
If the radio module is installed in a laptop display, transmission MUST be prevented if the lid is
closed to ensure that the minimum distance of 20 cm between the user and the transmitting
antenna is maintained.
Any notification to the end user of installation or removal instructions about the integrated ra-
dio module is NOT allowed.
7.4 Japanese Approval Certificate for cB-0901-0301
cB-0901-0301 is approved for Japan with a Japanese Approval Certificate for Radio Equipment.
Before using the product in Japan connectBlue must be contacted for further details.
This device contains
FCC ID: PVH090103L
IC: 5325A-090103L
Version 1.16 - 2009-12
44