SP100R BANNER ENGINEERING, SP100R Datasheet - Page 12

• Manufacturer Part Number: SP100R
• Description: PHOTO SENSOR RECEIVER
• Manufacturer: BANNER ENGINEERING

Specifications of SP100R

• Output Current: 150mA
• Sensor Output: NPN Open Collector
• Supply Voltage Range Dc: 10V To 30V
• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No

12
"AND": all inputs low energizes N/O output.
"NOR": all inputs high energizes N/O output.
"X-NOR" ("exclusive NOR"):
MICRO-AMP
MA4G 4-input Gate Logic Module
MICRO-AMP
It offers three selectable logic modes: "AND", "NOR", and "X-NOR" (exclusive
"NOR"). In the AND gate mode, the output(s) will change state when all four inputs are
low simultaneously. The NOR logic mode requires that all four inputs be high at the
same time for the output(s) to change state. The output(s) will change state in the X-NOR
mode when all four inputs are simultaneously either high or low. The MA4G may be
used as a 2, 3 or 4-input gate. Unused inputs are simply tied low (to pin #3) or left
unconnected (high), depending upon the logic mode in use.
The MA4G directly accepts the outputs of other MICRO-AMP modules plus the NPN
(current sinking) output of self-contained dc sensors.
MICRO-AMP MA4G Specifications
SUPPLY VOLTAGE: 10 to 30V dc at less than 20 milliamps
(exclusive of load); 10% maximum ripple.
INPUTS: INPUT and INHIBIT both respond to a logic "low" signal
(less than 2V dc). A logic "high" is at least 6V dc or an open circuit.
Inputs must be capable of sinking at least 4 milliamps. Inputs may be
derived from limit switches or from dc sensors with NPN (current
sinking) output transistors.
RESPONSE SPEED: all INPUTS will respond to a low signal or
high signal of 1 millisecond duration or longer.
OUTPUT CONFIGURATION: two open-collector NPN transis-
tors with complementary outputs (one normally open, one normally
closed). Maximum sinking current 150 milliamps, each output.
Truth Table
This table lists the various input states and their corre-
sponding outputs available in each logic mode. The
key to reading the table is given below. Logic state-
ments in the table read down the columns. For ex-
ample, in the first column, if the selector control is at
"AND" and all four inputs are logic low, the MA4G's
N/O output is low, the N/C output is high, and the LED
indicator is "on".
Functional Schematic, MA4G LOGIC Module
Truth Table Key
H = logic HIGH
L = logic LOW
X = either HIGH or LOW (does not matter)
Any input(s) high energizes N/C output.
Any input(s) low energizes N/C output.
All inputs the same energizes N/O output.
All inputs not the same energizes N/C output.
®
module MA4G is a 10 to 30V dc, plug-in, 4-input logic gate module.
®
System
Saturation voltage less than 0.5V dc at 10 milliamps. Off-state leakage
current less than 1 microamp.
SELECTOR SWITCH: single-turn potentiometer selects logic
mode. Fully clockwise = NOR mode; fully counterclockwise = AND
mode; midpoint = X-NOR mode.
INDICATOR: red LED indicator on the top of the module lights
whenever the N/O output is conducting.
CONSTRUCTION: totally encapsulated plug-in package with
molded VALOX
OPERATING TEMPERATURE:
0 to 70 degrees C (32 to 158 degrees F).
Hookup Diagram, MA4G LOGIC Module
®
housing. Gold-flashed connection pins.