RPBR BANNER ENGINEERING, RPBR Datasheet - Page 13

• Manufacturer Part Number: RPBR
• Description: PHOLOELECTRIC SENSOR
• Manufacturer: BANNER ENGINEERING

Specifications of RPBR

• Output Current: 5A

Model RPBU Power Block:
Model RPBTLM is a miniature dc power block for MAXI-BEAM sensors. It
may be used with any of the MAXI-BEAM sensor head models. The RPBTLM
is supplied with stainless steel hardware used for assembly of the MAXI-BEAM
components. Components simply bolt together, with no interwiring necessary.
The screws supplied are extra-long, and serve as a means to mount the complete
MAXI-BEAM sensor assembly to an object or surface.
The RPBTLM may be attached to its sensor head at any of four 90-degree
increments to allow the best cable exit direction (front, rear, or either side). A
logic module may be added and can be independently rotated (in the same
manner) for easiest access to the timing adjustments.
Outputs are in the bi-polar configuration: one current-sinking (NPN) plus one
current-sourcing (PNP). This design permits direct interfacing of the MAXI-
BEAM sensor to almost any type of dc logic input. Each output is rated for 150
mA. Either output may be used alone, or both may be used simultaneously. The
outputs may be configured for either normally open or normally closed operation
via the sensor head (or logic module) programming ring. The RPBTLM includes
an LED indicator to show the output status.
The RPBTLM is completely solid-state and epoxy-encapsulated. It is gasketed
to other MAXI-BEAM components by a quad-ring seal. See pages 3,7, and 14-
15 for information on the assembly and programming of MAXI-BEAM sensors.
INPUT: 12-250V ac (50/60Hz) or 12-30V dc, 40mA exclusive of load at 30V dc. OUTPUT: Optically-isolated SPST solid-state relay; 240V ac or dc max.,
100mA max. On-state voltage drop is 2 volts max. at 100mA (full rated load). DC hookup is without regard to polarity.
Specifications
INPUT: 10 to 30V dc, 10% maximum ripple.
OUTPUT CONFIGURATION: bi-polar. One current sinking (NPN) and one
current sourcing (PNP) open-collector transistor switch.
OUTPUT RATING: 150mA maximum each output at 25 C (derated to 100mA
at 70 C). Derate 1mA per C.
OUTPUT PROTECTION: protected against false pulse on power-up, inductive
load transients, power supply polarity reversal, and continuous overload or short-
circuit of outputs.
MAXI-BEAM
Hookup Diagram
Model RPBTLM
universal power input and output
Power Blocks
WARNING: Connection
of voltage directly
across pins 3 and 4,
without a load present,
will destroy the
switching element.
Low Profile DC Power Block
ON-STATE VOLTAGE DROP:
NPN output less than 200 millivolts at 10mA and less than
one volt at 150mA. PNP output less than 1 volt at 10mA and
less than 2 volts at 150mA.
OFF-STATE LEAKAGE CURRENT:
less than 1 microamp.
RPBTLM Dimensions
Functional Schematic
13