RPBR BANNER ENGINEERING, RPBR Datasheet - Page 14

• Manufacturer Part Number: RPBR
• Description: PHOLOELECTRIC SENSOR
• Manufacturer: BANNER ENGINEERING

Specifications of RPBR

• Output Current: 5A

14
MAXI-BEAM Logic Module Specifications
SUPPLY VOLTAGE: input power is supplied by the power block
(see pages 8-13).
RESPONSE TIME:
RLM5: add sensor response delay of approximately 2% of maximum
OFF-DELAY time.
RLM8: no added response time for ONE-SHOT mode.
TIMING ADJUSTMENTS: two 15-turn clutched potentiometers
with brass element, accessible from outside of logic module, under o-
ring gasketed cover screws.
RLM5
Program Definition
MAXI-BEAM
Model and Logic Functions
Logic Modules
MAXI-BEAM sensors offer built-in timing logic with the addition of a logic module. There
are two logic modules available. Model RLM5 is programmable for ON-DELAY, OFF-
DELAY, and ON/OFF DELAY timing logic. Model RLM8 offers both ONE-SHOT and
DELAYED ONE-SHOT functions. A programming ring is supplied with each logic
module. Programming of the logic function, timing range, and output state is similar to
sensor head programming.
Both logic modules feature 15-turn, clutched potentiometers for accurate timing adjust-
ments. Once programmed, the logic module may be rotated in 90-degree increments to
position the timing adjustments for easiest access. Logic modules are housed in the same
tough molded VALOX
module and its programming ring simply slip between the MAXI-BEAM sensor head and
power block (see photograph, page 3). The assembly is bolted together with no interwiring
necessary. The component interfaces are quad-ring sealed.
TIMING REPEATABILITY: plus or minus 2% of the maximum
time of the selected range, assuming conditions of constant operating
temperature and power supply voltage.
TIMING RANGE: 15 second ranges: 0.5 to 15 seconds; 1 second
ranges: 0.1 to 1 second; 0.1 second ranges: 0.01 to 0.1 second.
CONSTRUCTION: reinforced molded VALOX
ring gasketed. Electronics fully epoxy encapsulated. NEMA 1,3,4,12,
13.
OPERATING TEMPERATURE: -40 to +70 degrees C
(-40 to +158 degrees F).
PROGRAM CHOICES:
1) Timing Logic Function:
2) Timing Adjustment Range (see options below)
3) Output State:
TO PROGRAM LOGIC MODULE:
1) Find the programming notch which lines up with the program choice. NOTE:
the programming ring may have to be turned upside-down in order to find a notch
that lines up with the desired program.
2) Press the programming ring and logic module together. They will be held
together temporarily by their interlocking pegs.
3) Orient the logic module for easiest access to the timing adjustments, and
assemble between the programming ring of the sensor head and the power block
(see exploded view on page 3). Bolt all parts together with the long bolts that are
supplied with the logic module.
4) Apply power to the MAXI-BEAM and adjust timing, using a small flat-blade
screwdriver. Timing potentiometers are located behind the nylon o-ring gas-
keted cover screws.
®
a) ON-delay b) OFF-delay c) ON/OFF-delay
a) normally open b) normally closed
which is used for the other MAXI-BEAM components. The logic
Programming
®
housing, quad-