83699 SENSONOR TECHNOLOGIES AS, 83699 Datasheet - Page 7

• Manufacturer Part Number: 83699
• Description: SENSOR, PRESSURE, COMP, SP100-1T
• Manufacturer: SENSONOR TECHNOLOGIES AS

Specifications of 83699

• Operating Temperature Range: -40°C To +125°C
• Pressure Type: Absolute
• Ic Generic Number: SP100-1T
• No. Of Pins: 14
• Operating Pressure Range: 0 To 100kPa
• Sensor Case Style: SOIC
• Supply Voltage: RoHS Compliant
• Rohs Compliant: Yes

4
5
6
Notes:
Prolonged exposure to values between recommended operating conditions and absolute maximum ratings might
affect the performance and reliability of the device.
The product provides two outputs, which may be used to interrupt or reset a microcontroller. Each output provides a
pulse at regular intervals. The “wake-up and reset” are active low outputs. The Wake Up period typical value is
programmable from 1 to 256 seconds, in 1 second intervals.
Table 5.1 Wake-up and reset outputs
Notes:
The product has two oscillators: One low-power oscillator, which runs at about 2.5 kHz and is used for interval
timing, and a 2 MHz oscillator used for measurements and data transmission. Due to its very low current
consumption, the low-power oscillator is sensitive to temperature and supply voltage variation. To keep the interval
lengths constant under different conditions, the low-power oscillator is compared to the 2 MHz oscillator during each
measurement, and a correction is applied to the interval count. This operation is called an auto calibration. The
stability of the interval depends on the change in temperature or supply voltage since the last measurement.
The SPI interface is the communication protocol to the external microcontroller. This maximum serial clock frequency
is 500 kHz.
The SPI consists of a shift register, a command latch and failure latches, and encoder/decoder logic.
TS1483 rev. 1
Description
Input pressure
Temperature
Temperature transient
Storage temperature
Supply voltage
Input voltage, any pin
Input current, any pin (transient)
ESD protection (human body model)
ESD protection (charge device model)
Absolute Maximum Ratings
Wake-Up and Reset Outputs
Serial Interface
Interval timing drift over
Interval timing drift over
1)
2)
3)
4)
5)
1)
supply voltage
Wake Up Width
The component will also withstand standard reflow soldering, accumulated time < 2.5 hours.
Less than 3 min.
Accumulated time at 150°C not to exceed 500hours to avoid permanent damage. Solder ability may be affected with less exposure.
According to AEC-Q100-002 Rev. C or JESD22-A114 Rev. F
According to AEC-Q100-011 Rev. B or JESD22-C101 Rev. D
See text describing oscillators below.
temperature
Reset period
Reset width
Parameter
1)
1)
3)
1)
2)
DATASHEET
0.13
0.13
Min
4)
5)
Typ
0.6
-15
51
Max
2.5
2.5
-40
1
SP100 PRESSURE SENSOR SERIES
- 7 -
-100
Min
-0.3
-0.3
-40
-40
-40
%/°C
Unit
%/V
min
ms
ms
Typ
±2000V to any pin
±500V to any pin
VDD + 0.3
+150
+175
+150
+100
SP100-1(T), SP100-2(T)
Max
600
6.0
Units
kPa
mA
°C
°C
°C
V
V