G306K000 Red Lion Controls, G306K000 Datasheet - Page 3

• Manufacturer Part Number: G306K000
• Description: Kadet 6 Inch TFT
• Manufacturer: Red Lion Controls
• Type: Color Graphicr

Specifications of G306K000

• Current, Consumption: 200 mA
• Dimensions: 7.56 W × 5.43 H In.
• Display Size: 5.6 In.
• Memory: 2 Mb Flash
• Mounting Type: Panel
• Primary Type: Operator Interface
• Resolution: 320 × 234 Pixel TFT
• Resolution, Display: 320 × 234
• Size: 6 In. Color TFT
• Standards: CE Approved, cULus Listed
• User Interface: Touchscreen
• Voltage, Supply: 12-24 VDC

CONNECTING POWER
the following points:
are exposed via one DB9 male, and one DB9 female connector. You may assign
one unique protocol to each of the Programming, Comms and Auxiliary ports
for a total of three different serial protocols.
be able to download. You should create a means to call the StopSystem()
function from the HMI touchscreen, such that the Programming Port activity
can be halted on command. Alternatively, the HMI's memory can be cleared to
restore download functionality.
simultaneously. For more information on protocol support, please refer to the
Crimson 2.0 programming software.
PC CONNECTION
be connected to a computer via various cables.
C
RJ-45 Ethernet
The G306K requires a 12-24 VDC power supply. Please take care to observe
The G306K has three serial ports, as well as an Ethernet port. The serial ports
Note: If you assign a protocol to the Programming Port, you will no longer
The Ethernet port can be programmed to communicate via four protocols
Configuration files are downloaded to the Kadet via the PC port, which can
- The wire used to connect the operator interface’s power supply should be
- A power supply with a Class 2 or SELV rating is to be used. A Class 2 or
OMMUNICATING
at least 22-gage wire. If a longer cable run is used, a heavier gage wire
should be used. The routing of the cable should be kept away from large
contactors, inverters, and other devices which may generate significant
electrical noise.
SELV power supply provides isolation to accessible circuits from
hazardous voltage levels generated by a mains power supply due to
single faults. SELV is an acronym for “safety extra-low voltage.”
Safety extra-low voltage circuits shall exhibit voltages safe to touch
both under normal operating conditions and after a single fault, such as
a breakdown of a layer of basic insulation or after the failure of a single
component has occurred.
PROGRAMMING
PT# CBLUSB23 (includes CBLSK000)
RS-232 PC
DB9-M
W
USB to Serial
ITH THE
3
PLC
COMMS
AUXILIARY
G306K
RS-485 (4-wire)
RS-232 AUX
DB9-M
DB9-F
PT# CBLSK000
Cable
RS-485 (2-wire)
RS-485 AUX
DB9-M
DB9-M
RS-232
DB9-F