702572 Spectrum Digital Inc, 702572 Datasheet - Page 13

• Manufacturer Part Number: 702572
• Description: XDS560R Target Adapter Cable For 14 Pin JTAG Header
• Manufacturer: Spectrum Digital Inc

Specifications of 702572

• Accessory Type: Target Adapter
• Features: Compatible With XDS510USB PLUS / XDS560R From Spectrum Digital, Includes 14 Pin JTAG Header
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: XDS510USB PLUS Or XDS560R USB JTAG Emulator
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: Q5346474

2.2 Installing the XDS560R JTAG Emulator
2.2.1 XDS560R USB Installation Checklist
Target Cable Connectors:
This section contains the steps for installing the XDS560R JTAG Emulator.
Do not connect or disconnect the emulator tail while the target system is powered up.
The following section provides instructions to install XDS560R using the USB interface.
To install the XDS560R JTAG emulator using the USB interface execute the following
checklist:
❏
❏
❏
❏
❏
❏
Be very careful with the target cable connectors. connect them gently; don’t force
them into position, or you may damage the connectors.
blinking slowly and LED 1-3 should begin sequencing. At this point the XDS560R has
the AC power cord.
XDS560R located at the rear of the emulator. when power is connected the “PWR”
led on the XDS560R should iulluminate. After about 3 seconds LED 0 should begin
gone through it’s power on self-test, entered boot mode and is ready for USB
enumeration.
configuration should now look like that in Figure 2-1or Figure 2-2. Now connect the
XDS560R to your PC using the supplied USB cable. At this point led 0 should begin
blinking at a faster rate and windows will launch its “Add New Hardware Wizard” and
prompt for the location of the XDS560R drivers. Follow the instructions in the Quick
Start Guide for the software tools you are using.
to the target board
Turn off the power to your target board.
Connect the supplied USB cable to your PC or laptop. If you connect the USB cable
Connect the included +5V power adapter brick to your wall AC power source using
Apply power to the XDS560R by connecting the power brick to the +5V input on the
Make sure your driver CD-ROM is installed in your CD-ROM drive. Your system
Now connect the tail of the emulator to the header on your target board. Apply power
to a USB hub be sure the hub is connected to the PC or laptop and power is applied
to the hub.
WARNING !
Spectrum Digital, Inc
2-3