AS3992-BQFP-50 austriamicrosystems, AS3992-BQFP-50 Datasheet - Page 8

• Manufacturer Part Number: AS3992-BQFP-50
• Description: IC UHF RFID READER 64-QFN
• Manufacturer: austriamicrosystems

Specifications of AS3992-BQFP-50

• Rf Type: UHF
• Frequency: 900MHz
• Features: ISO18000-6-A/B, EPC UHF Class 1, EPC UHF Gen 2
• Package / Case: 64-VFQFN Exposed Pad
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: AS3992-BQFP-50TR

AS3992
Data Sheet - A b s o l u t e M a x i m u m R a t i n g s
5 Absolute Maximum Ratings
Stresses beyond those listed in
the device at these or any other conditions beyond those indicated in
maximum rating conditions for extended periods may affect device reliability.
Table 2. Absolute Maximum Ratings
1. AGD (Pin 54) excluded from Latchup immunity test for EN (Pin 39) is high. AGD is a reference voltage pin and must be kept at the refer-
2. This integrated circuit can be damaged by ESD. We recommend that all integrated circuits are handled with appropriate precautions.
www.austriamicrosystems.com/AS3992
Lead temperature 1.6 mm (1/16 inch) from case
ence voltage level for proper chip operation. AGD must be connected to an external stabilization capacitor.
Failure to observe proper handling and installation procedures can cause damage. ESD damage can range from subtle performance
degradation to complete device failure. Precision integrated circuits may be more susceptible to damage because very small parametric
changes could cause the device not to meet the published specifications. RF integrated circuits are also more susceptible to damage
due to use of smaller protection devices on the RF pins, which are needed for low capacitive load on these pins.
ESD rating
Maximum junction temperature T
Storage temperature range, T
Supply voltage, all other pins
Negative voltage other pads
Supply voltage, V
Positive voltage other pads
Latchup immunity
2
for 10 seconds
Parameter
EXT,
RF pins, HBM
IO pins, HBM
Table 2
1
, I
V
EXT2
O
stg
may cause permanent damage to the device. These are stress ratings only, and functional operation of
J
Min
-55
V
S
±100
+150
Max
-0.3
120
260
5.5
± 0.3
7
2
1
Revision 1.0
Electrical Characteristics on page 9
Units
mA
kV
kV
ºC
ºC
ºC
V
V
V
V
The maximum junction temperature for continuous
operation is limited by package constraints.
The reflow peak soldering temperature
According to MIL 883 E method 3015
Classification for non-hermetic Solid
according IPC/JEDEC J-STD-020C
(body temperature) is specified
State Surface Mount Devices”.
“Moisture/Reflow Sensitivity
According to JEDEC 78
is not implied. Exposure to absolute
Comments
8 - 52