S1D13700F01A100 Epson, S1D13700F01A100 Datasheet - Page 150

• Manufacturer Part Number: S1D13700F01A100
• Description: Display Drivers LCD CONTROLLER
• Manufacturer: Epson

Specifications of S1D13700F01A100

• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Operating Temperature Classification: Industrial
• Package Type: TQFP
• Pin Count: 80
• Mounting: Surface Mount
• Operating Supply Voltage (min): 2.7V
• Lead Free Status / Rohs Status: Supplier Unconfirmed

Panel Information
S1D13705F00A UTILITIES (X27A-B-001-01)
The panel information portion of CFG tab describes the panel to be connected to the S1D13705.
This section of the 1375CFG dialog describes the panel connected to the S1D13705. Each of the
settings are described briefly below.
• Mono / Color
• Single / Dual
• STN / TFT
• 4 Bit / 8 Bit
• Dimensions
• Mask FPSHIFT
Select mono for monochrome panels or color for color panels. This option is STN specific and is
disabled if TFT is selected.
Select single for a single panel or dual for a dual panel. This option is STN specific and is
disabled if TFT is selected.
Select STN for passive panels or TFT for active panels. Selecting STN enables all the STN
options and disables (grays out) the TFT specific settings. Selecting TFT enables the TFT
settings and disables STN specific settings.
These radio buttons are STN/TFT specific. When STN is selected the options are “4 Bit” and “8
Bit”. Selecting a TFT type panel changes these options to “9 Bit” and “12 Bit”. Select the data
width as appropriate for your panel.
Note: panel data width is not the same as color depth.
In the left selection box enter the panel width in pixels and in the right selection box enter the
panel height in pixels.
Values in the selection boxes can be either chosen from the drop-down list or typed directly into
the edit portion of the selection box.
This option is required by most newer monochrome panels. Whenever either color panel or TFT
is selected this option is disabled.
- selects whether the attached panel is monochrome or color.
- selects whether the panel is a single STN or dual STN.
- determines the technology used to construct the panel.
- these setting select the data width the panel requires.
- the two boxes in the upper right corner of the CFG tab allow
- when selected causes the signal FPSHIFT to be masked.
selecting the panel dimensions.
Figure 1-2 Panel Information
EPSON
1: 1375CFG CONFIGURATION PROGRAM
3-3