264-15/T2C4-2NRA Everlight Electronics CO., LTD, 264-15/T2C4-2NRA Datasheet - Page 9

• Manufacturer Part Number: 264-15/T2C4-2NRA
• Description: Standard LED - Through Hole White Water Clear 2250-5650mcd, 20mA
• Manufacturer: Everlight Electronics CO., LTD

Specifications of 264-15/T2C4-2NRA

• Led Size: T-1
• Illumination Color: White
• Lens Color/style: Water Clear
• Operating Voltage: 3 V
• Operating Current: 20 mA
• Lens Shape: Circular
• Mounting Style: Through Hole
• Viewing Angle: 40 deg
• Package / Case: T-1
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Revision
LifecyclePhase:Preliminary
LifecyclePhase:
Technical Data Sheet
Notes
1. Lead Forming
2. Storage
3. Soldering
Everlight Electronics Co., Ltd.
Device Number: DLE-0000038
Temp. at tip of iron
Soldering time
Distance









: (1)
During lead formation, the leads should be bent at a point at least 3mm from the base of the
epoxy bulb.
Lead forming should be done before soldering.
Avoid stressing the LED package during leads forming. The stress to the base may damage
the LED’s characteristics or it may break the LEDs.
Cut the LED leadframes at room temperature. Cutting the leadframes at high temperatures
may cause failure of the LEDs.
When mounting the LEDs onto a PCB, the PCB holes must be aligned exactly with the lead
position of the LED. If the LEDs are mounted with stress at the leads, it causes deterioration
of the epoxy resin and this will degrade the LEDs.
The LEDs should be stored at 30°C or less and 70%RH or less after being shipped from
Everlight and the storage life limits are 3 months. If the LEDs are stored for 3 months or
more, they can be stored for a year in a sealed container with a nitrogen atmosphere and
moisture absorbent material.
Please avoid rapid transitions in ambient temperature, especially, in high humidity
environments where condensation can occur.
Careful attention should be paid during soldering. When soldering, leave more then 3mm
from solder joint to epoxy bulb, and soldering beyond the base of the tie bar is
recommended.
Recommended soldering conditions:
Hand Soldering
300℃ Max. (30W
Max.)
3 sec Max.
3mm Min.(From solder
joint to epoxy bulb)
Established date:10-01-2008
http\\:www.everlight.com
Preheat temp.
Bath temp. & time 260 Max., 5 sec Max
Distance
Release Date:
Expired Period: Forever
264-15/T2C4-2NRA
DIP Soldering
Established by: Ruby Lin
Rev
100 ℃ Max. (60 sec
Max.)
3mm Min. (From solder
joint to epoxy bulb)
1
Page: 9 of 12