GW5BTF65K00 Sharp Microelectronics, GW5BTF65K00 Datasheet - Page 14

• Manufacturer Part Number: GW5BTF65K00
• Description: LED High Power (> 0.5 Watts) 6.7W Mini Zenigata 6500K CCT
• Manufacturer: Sharp Microelectronics
• Series: Miniature Zenigatar

Specifications of GW5BTF65K00

• Led Module Type: Board + LED
• Led Color: Cool White
• Cct: 7040K
• Luminous Flux @ Test: 410lm
• Power Module Configuration: Square
• Supply Voltage: 10.2V
• Forward Current @ Test: 640mA
• Power Rating: 6.7W
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

⑤ Connecting method
⑥ Static electricity
⑦ Drive method
⑧ Cleaning
⑨ Color-tone variation
・ Do not touch resin part including white resin part on the surface of LED.
・Use Soldering iron with thermo controller (tip temperature 380 ℃), within 5 seconds per one place.
・Secure the solderwettability on whole solder pad and leads.
・During the soldering process, put the ceramic board on materials whose conductivity is poor enough
・Warm up (with using a heated plate) the substrate is recommended before soldering.
・Avoid touching a part of resin with soldering iron.
・This product is not designed for reflow and flow soldering.
・Avoid such lead arrangement as applying stress to solder-applied area.
・Please do not detach solder and make re-solder.
・Please solder evenly on each electrodes.
・Please prevent flux from touching to resin.
・Any reverse voltage cannot be applied to LEDs when they are in operation or not.
・Module is composed of LEDs connected in both series and parallel.
In case of solder connecting method, follow the conditions mentioned below.
This product is subject to static electricity, so take measures to cope with it.
Install circuit protection device to drive circuit, if necessary.
Avoid cleaning, since silicone resin is eroded by cleaning.
Chromaticity of this product is monitored by integrating sphere right after the operation.
Chromaticity varies depending on measuring method, light spread condition, or ambient temperature.
Please verify your actual conditions before use.
not to radiate heat of soldering.
Design a circuit so that any flow of reverse or forward voltage can not be applied to LEDs
when they are out of operation.
Constant voltage power supply runs off more than specified current amount due to lowered V
caused by temperature rise.
Constant current power supply is recommended to drive.
( preheat condition: 100 ℃ ～ 150 ℃, within 60 sec )
No light emission may occur due to damage of resin or cutting wire of LEDs by outer force.
When using tweezers, please handle by ceramic substrate part and avoid touching resin part.
For mounting, please handle by side part of ceramic or the specified area shown below.
Handling area
Model No.
GW5BTF65K00
F
DG-09Z030A
Page
11 of 12