UDS100-B Lantronix, UDS100-B Datasheet - Page 33

• Manufacturer Part Number: UDS100-B
• Description: Ethernet Modules & Development Tools Single Port
• Manufacturer: Lantronix
• Type: Serial to Ethernetr

Specifications of UDS100-B

• Data Rate: 300 bps to 115.2 Kbps
• Product: Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

UDS10/UDS100 User Guide
Disconnect Mode
This option determines the conditions under which the unit causes a network
connection to terminate. In DisConnMode, DTR drop either drops the connection or is
ignored.
Note:
1. The UDS sends the "Terminal Type" upon an outgoing connection.
2. A password is required for a connection to the serial port from the network.
3. The TCP connection closes even if the remote site does not acknowledge the
4. When there is a network connection to or from the serial port, the state LED
5. When Ctrl D or Hex 04 are detected, the connection is dropped. Both Telnet
Flush Mode
Flush Mode (buffer flushing) controls line handling and network buffers with
connection startup and disconnect. You can select between two different packing
algorithms.
Note:
Available Flush Mode options are:
Function
Input Buffer (Serial to Network)
Clear with active connection (from serial)
Clear with passive connection (from network)
Clear with disconnect
Output Buffer (Network to Serial)
Clear with active connection (from serial)
Clear with passive connection (from network)
Clear with disconnect
Alternate Packing Algorithm (Pack Control)
Enable
disconnection.
turns off instead of blinking.
mode and Disconnect with EOT must be enabled for Disconnect with EOT to
function properly. Ctrl D is only be detected going from the serial port to the
network.
Disconnect Mode Option
Disconnect with DTR drop
Ignore DTRa
Telnet mode and terminal type setup
Channel (port) password
Hard disconnect
Disable hard disconnect
State LED off with connection
Disconnect with EOT (^D)
To look up hex values, see
To look up hex values, see
Table 5-9. Disconnect Mode Options
3
Table 5-10. Flush Mode Options
2
5
Configuring the UDS Using Telnet or the Serial Port
4
33
B: Binary to Hexadecimal.
B: Binary to Hexadecimal.
1
Bit 7 6 5 4 3 2 1 0
1
0
Bit 7 6 5 4 3 2 1 0
1
1
1
1
1
1
0
1
1
1
1
1
1