RK-WI.USB-DTS-R Radiotronix, RK-WI.USB-DTS-R Datasheet - Page 8

• Manufacturer Part Number: RK-WI.USB-DTS-R
• Description: RF Modules & Development Tools Wi.USB-DTS Dev Kit w/ Rohs Base St
• Manufacturer: Radiotronix

Specifications of RK-WI.USB-DTS-R

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: RK-WIUSB-DTS-R

WI.USB-DTS-R DATASHEET
3. Using Wi.USB-DTS-R
The software supplied with the Wi.USB-DTS™ is used to read and set the volatile and non-volatile registers
within the Wi.232DTS™ module contained within. Additionally, it provides a chat interface for basic information
exchange. Please refer to the Wi.232DTS™ User’s Manual for more information on the register settings.
3.1. COM Port
Upon starting the Wi.USB-DTS™ evaluation software, you will be presented
with a COM port selection dialog box. Make sure that the Wi.USB-DTS™ unit is
already connected to the computer via the USB cable before you start the
software. This will ensure that the virtual COM port which is assigned to the
USB to UART bridge controller by Windows is visible in the COM port selection
list. Select the COM port used by the Wi.USB-DTS™. If you need to find out
which COM port this is, go to Control Panel > System Properties > Hardware
Tab > Device Manager > Ports (COM & LPT) > CP2101 USB to UART.
The first time you start the Wi.USB-DTS™ evaluation software, the Baud Rate
should be left at 2400 baud, since this is the factory default baud rate setting for
the unit.
Tip: The Wi.USB-DTS™ evaluation software does not auto-detect the baud
rate of the module. If you have changed the Non-Volatile Data Rate register,
you will have to select the baud rate you set this register to when you start the
Wi.USB-DTS™ evaluation software.
TM
Evaluation Software
7
Figure 2: COM Port
Selection
Chapter
3