LM3674MFX-1.2 National Semiconductor, LM3674MFX-1.2 Datasheet - Page 14

• Manufacturer Part Number: LM3674MFX-1.2
• Description: IC,SMPS CONTROLLER,VOLTAGE-MODE,TSOP,5PIN,PLASTIC
• Manufacturer: National Semiconductor

www.national.com
Application Information
Good layout for the LM3674 can be implemented by follow-
ing a few simple design rules, as illustrated in .
1.
2. Arrange the components so that the switching current
3. Connect the ground pins of the LM3674, and filter ca-
4. Use wide traces between the power components and for
together and make the traces short. The traces between
these components carry relatively high switching cur-
rents and act as antennas. Following this rule reduces
radiated noise. Special care must by given to place the
input filter capacitor very close to the V
loops curl in the same direction. During the first half of
each cycle, current flows from the input filter capacitor,
through the LM3674 and inductor to the output filter
capacitor and back through ground, forming a current
loop. In the second half of each cycle, current is pulled
up from ground, through the LM3674 by the inductor, to
the output filter capacitor and then back through ground,
forming a second current loop. Routing these loops so
the current curls in the same direction prevents mag-
netic field reversal between the two half-cycles and re-
duces radiated noise.
pacitors together using generous component-side cop-
per fill as a pseudo-ground plane. Then, connect this to
the ground-plane (if one is used) with several vias. This
reduces ground-plane noise by preventing the switching
currents from circulating through the ground plane. It
also reduces ground bounce at the LM3674 by giving it
a low-impedance ground connection.
power connections to the DC-DC converter circuit. This
Place the LM3674, inductor and filter capacitors close
FIGURE 5. Board Layout Design Rules for the LM3674
(Continued)
IN
and GND pin.
14
5. Route noise sensitive traces, such as the voltage feed-
6. Place noise sensitive circuitry, such as radio IF blocks,
In mobile phones, for example, a common practice is to
place the DC-DC converter on one corner of the board,
arrange the CMOS digital circuitry around it (since this also
generates noise), and then place sensitive preamplifiers and
IF stages on the diagonally opposing corner. Often, the
sensitive circuitry is shielded with a metal pan and power to
it is post-regulated to reduce conducted noise, using low-
dropout linear regulators.
reduces voltage errors caused by resistive losses across
the traces.
back path, away from noisy traces between the power
components. The voltage feedback trace must remain
close to the LM3674 circuit and should be direct but
should be routed opposite to noisy components. This
reduces EMI radiated onto the DC-DC converter’s own
voltage feedback trace. A good approach is to route the
feedback trace on another layer and to have a ground
plane between the top layer and layer on which the
feedback trace is routed. In the same manner for the
adjustable part it is desired to have the feedback divid-
ers on the bottom layer.
away from the DC-DC converter, CMOS digital blocks
and other noisy circuitry. Interference with noise-
sensitive circuitry in the system can be reduced through
distance.
20167231