A3PA-5733-24E Omron, A3PA-5733-24E Datasheet - Page 25

• Manufacturer Part Number: A3PA-5733-24E
• Description: GREEN/GREEN DISPLAY
• Manufacturer: Omron
• Series: A3Pr

Specifications of A3PA-5733-24E

• Actuator Style: Square Button
• Illumination Type: Led
• Product Height (mm): 59.3mm
• Product Depth (mm): 25mm
• Operating Temp Range: -10C to 40C
• Mounting Style: Panel
• Terminal Type: Quick Connect/Solder
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: A3PA573324E; A3PA573324ENC

Assembly/Disassembly
A3PJ/M2PJ (Rectangular Models), A3PA/M2PA (Square Models)
Locking/Unlocking Positive Cap Lock Mechanism
Mounting Pushbutton
Removing/Mounting Cap
Insert the A3PA from the open side into the theft-prevention stopper.
Mounting Colored Plate
Place the colored plate on the plunger case with the dull side of the
colored plate facing downward.
With A3PJ split-screen models, be sure that the projections on the
upper surface of the colored plate face outward. For the A3PA, make
sure that the flat plate is facing upwards.
Mounting Character Plate (Character Frame) and Legend
Plate
Mount the legend plate for the A3PJ under the layered surfaces and
mount the cap, as shown below.
• Be sure to mount the Pushbutton with the correct orientation. Align
• When dismounting the Pushbutton, use the Extractor (A3PJ-5080)
the groove on the Pushbutton, the projections in the Switch, and the
LED contact piece before pushing the Pushbutton into the Switch.
for easy dismounting.
A3PJ
OMRON logo
Projection
Colored plate
Legend plate
Unlock
LED contact piece
Transparent cap
(Light baffle)
A3PA
Lock
Diagram shows A3PA model.
Positive cap stopper
(Character plate)
Flat plate
Groove
Mounting and Replacing LED and Incandescent Lamps
If using an A3PA (square) model with one incandescent lamp, insert
the lamp in the center hole.
LED Rated Voltage Display (LED Models Only)
The LED rated voltage is shown between the built-in resistors on the
back of the lighting unit. Use within a range of ± 5%.
Mounting Switch onto Panel
Mounting Barriers
Mount each part by pushing it in the direction of the arrow shown in
the corresponding illustration below.
• Individual Mounting
and Barrier Mounting
When mounting the Switch,
push it into the panel cutout
from the front of the
mounting panel by holding it
with the logo mark
“OMRON” facing downward.
OMRON
logo
Note: Built-in LEDs cannot be replaced.
A3PJ
A3PA
• Multiple Barrier Mounting (A3PJ)
When mounting a number of Switches in
line on the panel, link the Switches with
spacing barriers in between, attach
mounting barriers at both sides of this block
of Switches and, pushing in on the
mounting barriers at the side, insert the
Switches into the panel cutout together.
Barrier mounting
OMRON
logo
Note: Display is on the back.
Rated
voltage display
A3P
25