WM8734SEFL Wolfson Microelectronics, WM8734SEFL Datasheet - Page 22

• Manufacturer Part Number: WM8734SEFL
• Description: Audio CODECs Stereo CODEC
• Manufacturer: Wolfson Microelectronics

Specifications of WM8734SEFL

• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: QFN-28
• Minimum Operating Temperature: - 25 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

WM8734
DEVICE OPERATION
w
Recommended values are C1 = 470nF (10V npo type), R1 = 47KΩ, R2 = 100Ω
C1 forms a DC blocking capacitor to the line outputs. R1 prevents the output voltage from drifting so
protecting equipment connected to the line output. R2 forms a de-coupling resistor preventing
abnormal loads from disturbing the device. Note that poor choice of dielectric material for C1 can
have dramatic effects on the measured signal distortion at the output.
DEVICE RESETTING
The WM8734 contains a power on reset circuit that resets the internal state of the device to a known
condition. The power on reset is applied as DCVDD powers on and released only after the voltage
level of DCVDD crosses a minimum turn off threshold. If DCVDD later falls below a minimum turn on
threshold voltage then the power on reset is re-applied. The threshold voltages and associated
hysteresis are shown in the Electrical Characteristics table.
The user also has the ability to reset the device to a known state under software control as shown in
the table below.
Table 5 Software Control of Reset
When using the software reset. In 3-wire mode the reset is applied on the rising edge of CSB and
released on the next rising edge of SCLK. In 2-wire mode the reset is applied for the duration of the
ACK signal (approximately 1 SCLK period, refer to Figure 24).
CLOCKING SCHEMES
In a typical digital audio system there is only one central clock source producing a reference clock to
which all audio data processing is synchronised. This clock is often referred to as the audio system’s
Master Clock. To allow WM8734 to be used in a centrally clocked system, the WM8734 is capable of
deriving the sample rate clock from this Master Clock (Master Mode) or receiving the sample rate
clock from an external source (Slave Mode).
CORE CLOCK
The WM8734 DSP core can be clocked either by MCLK or MCLK divided by 2. This is controlled by
software as shown in Table 6 below.
Table 6 Software Control of Core Clock
Having a programmable MCLK divider allows the device to be used in applications where higher
frequency master Clocks are available. For example the device can support 512fs master clocks
whilst fundamentally operating in a 256fs mode.
DIGITAL AUDIO INTERFACES
WM8734 may be operated in either one of the 4 offered audio interface modes. These are:
• Right justified
• Left justified
• I
• DSP mode
All four of these modes are MSB first and operate with data 16 to 32 bits, except right justified mode
which does not support 32 bits.
0001111
Reset Register
0001000
Sampling
Control
2
REGISTER
S
ADDRESS
REGISTER
ADDRESS
6
BIT
8:0
BIT
CLKIDIV2
RESET
LABEL
LABEL
0
DEFAULT
not reset
DEFAULT
Reset Register
Writing 00000000 to register resets
device
1 = Core Clock is MCLK divided by 2
0 = Core Clock is MCLK
Core Clock divider select
DESCRIPTION
DESCRIPTION
PD, Rev 4.3, January 2009
Production Data
22