LPC47N267-MV Standard Microsystems (SMSC), LPC47N267-MV Datasheet - Page 3

• Manufacturer Part Number: LPC47N267-MV
• Manufacturer: Standard Microsystems (SMSC)

Specifications of LPC47N267-MV

• Pin Count: 100
• Lead Free Status / RoHS Status: Compliant

100 Pin LPC Super I/O with X-Bus Interface
General Description
SMSC LPC47N267
The SMSC LPC47N267 is a 3.3V PC 99 and ACPI 1.0 compliant Super I/O Controller. The
LPC47N267 implements an LPC interface, a pin reduced ISA interface, for supported I/O and DMA
cycles. In addition, this part includes an X-Bus interface that may be accessed through the LPC
interface for supported I/O cycles (memory cycles are not supported by this device). The X-Bus
interface supports as many as four external components and it offers three different modes of operation
for interfacing with these components. The X-Bus interface has an added “Write Protect” feature that
ensures that the Base Address and disable bit for each component can only be set by the BIOS to
prevent corruption by any virus software. This part also includes 29 GPIO pins.
The LPC47N267 incorporates SMSC’s true CMOS 765B floppy disk controller, advanced digital data
separator, 16-byte data FIFO, two 16C550 compatible UARTs, one Multi-Mode parallel port with
ChiProtect circuitry plus EPP and ECP support and one floppy direct drive support. The LPC47N267
does not require any external filter components, is easy to use and offers lower system cost and
reduced board area. The LPC47N267 is software and register compatible with SMSC’s proprietary
82077AA core.
The true CMOS 765B core provides 100% compatibility with IBM PC/XT and PC/AT architectures and
provides data overflow and underflow protection. The SMSC advanced digital data separator
incorporates SMSC’s patented data separator technology allowing for ease of testing and use. The
LPC47N267 supports both 1Mbps and 2Mbps data rates and vertical recording operation at 1Mbps
Data Rate.
The LPC47N267 also features a full 16-bit internally decoded address bus, a Serial IRQ interface with
PCI nCLKRUN support, relocatable configuration ports and three DMA channel options.
Both on-chip UARTs are compatible with the NS16C550. One UART includes additional support for a
Serial Infrared Interface that complies with IrDA v1.2 (Fast IR), HPSIR, and ASKIR formats (used by
Sharp and other PDAs), as well as Consumer IR.
The parallel port is compatible with IBM PC/AT architectures, as well as IEEE 1284 EPP and ECP.
The parallel port ChiProtect circuitry prevents damage caused by an attached powered printer when
the LPC47N267 is not powered.
The LPC47N267 incorporates sophisticated power control circuitry (PCC). The PCC supports multiple
low power down modes. The LPC47N267 also features Software Configurable Logic (SCL) for ease
of use. SCL allows programmable system configuration of key functions such as the FDC, parallel
port, and UARTs.
The LPC47N267 supports the ISA Plug-and-Play Standard (Version 1.0a) and provides the
recommended functionaity to support Windows ‘95/’98 and PC99. The I/O Address, DMA Channel
and Hardware IRQ of each device in the LPC47N267 may be reprogrammed through the internal
configuration registers. There are 192 I/O address location options, a Serialized IRQ interface, and
three DMA channels.
PRODUCT PREVIEW
3
Revision 06-12-08