LCMXO2-1200ZE-1MG132CR1 Lattice, LCMXO2-1200ZE-1MG132CR1 Datasheet - Page 101

• Manufacturer Part Number: LCMXO2-1200ZE-1MG132CR1
• Description: IC PLD 1280LUTS 105I/O 132CSBGA
• Manufacturer: Lattice

Specifications of LCMXO2-1200ZE-1MG132CR1

• Programmable Type: *
• Number Of Macrocells: *
• Voltage - Input: *
• Speed: *
• Mounting Type: *
• Package / Case: *
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 220-1140

Lattice Semiconductor
• The on-chip differential input termination resistor value is higher than intended. It is approximately 200 as
• SED logic may not produce the correct result when it is run for the first time after configuration. To use this fea-
• Under certain conditions, IIH exceeds datasheet specifications. The following table provides more details:
• The user SPI interface does not operate correctly in some situations. During master read access and slave write
• In GDDRX2, GDDRX4 and GDDR71 modes, ECLKSYNC may have a glitch in the output under certain condi-
• Embedded Block RAM read back using the JTAG port does not operate correctly in some situations. Occasion-
• When using the hard I
• PLL Lock signal will glitch high when coming out of standby. This glitch lasts for about 10
• Dual boot only available on HC devices, requires tying VCC and VCCIO2 to the same 3.3V or 2.5V supply.
VPAD > VCCIO
VPAD = VCCIO
VPAD = VCCIO
VPAD < VCCIO
opposed to the intended 100. It is recommended to use external termination resistors for differential inputs. The
on-chip termination resistors can be disabled through Lattice design software.
ture, discard the result from the first operation. Subsequent operations will produce the correct result.
access, the last byte received does not generate the RXRDY interrupt.
tions, leading to possible loss of synchronization.
ally, the data is shifted early by 9 bits (the first 9-bit word is missing).
low.
Condition
2
C IP core, the I
Clamp
OFF
OFF
OFF
ON
2
C status registers I2C_1_SR and I2C_2_SR may not update correctly.
Pad Rising
IIH Max.
10µA
10µA
1mA
1mA
5-16
Pad Falling
IIH Min.
-10µA
-10µA
-1mA
-1mA
Steady State Pad
MachXO2 Family Data Sheet
High IIH
10µA
10µA
1mA
1mA
Ordering Information
µ
sec before returning
Steady State Pad
Low IIL
10µA
10µA
10µA
10µA