ICS9248AG-92LF IDT, Integrated Device Technology Inc, ICS9248AG-92LF Datasheet - Page 4

• Manufacturer Part Number: ICS9248AG-92LF
• Description: IC PENTIUM II CLOCK CHIP 48TSSOP
• Manufacturer: IDT, Integrated Device Technology Inc
• Type: Frequency Generatorr

Specifications of ICS9248AG-92LF

• Input: Crystal
• Output: Clock
• Frequency - Max: 100MHz
• Voltage - Supply: 3.135 V ~ 3.465 V
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 48-TSSOP
• Frequency-max: 100MHz
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 9248AG-92LF

How to Write:
• Controller (host) sends a start bit.
• Controller (host) sends the write address D2
• ICS clock will acknowledge
• Controller (host) sends a dummy command code
• ICS clock will acknowledge
• Controller (host) sends a dummy byte count
• ICS clock will acknowledge
• Controller (host) starts sending first byte (Byte 0)
• ICS clock will acknowledge each byte one at a time.
• Controller (host) sends a Stop bit
Notes:
1.
2.
3.
4.
5.
6.
through byte 5
The ICS clock generator is a slave/receiver, I
Read-Back will support Intel PIIX4 "Block-Read" protocol.
The data transfer rate supported by this clock generator is 100K bits/sec or less (standard mode)
The input is operating at 3.3V logic levels.
The data byte format is 8 bit bytes.
To simplify the clock generator I
bytes must be accessed in sequential order from lowest to highest byte with the ability to stop after any complete byte
has been transferred. The Command code and Byte count shown above must be sent, but the data is ignored for those
two bytes. The data is loaded until a Stop sequence is issued.
At power-on, all registers are set to a default condition, as shown.
Dummy Command Code
Dummy Byte Count
Controller (Host)
Address
Start Bit
Stop Bit
Byte 0
Byte 1
Byte 2
Byte 3
Byte 4
Byte 5
D2
(H)
How to Write:
For more information, contact ICS for an I
The information in this section assumes familiarity with I
General I
ICS (Slave/Receiver)
ACK
ACK
ACK
ACK
ACK
ACK
ACK
ACK
ACK
2
C interface, the protocol is set to use only "Block-Writes" from the controller. The
2
C serial interface information
(H)
2
C component. It can read back the data stored in the latches for verification.
4
2
C programming application note.
How to Read:
• Controller (host) will send start bit.
• Controler (host) sends the read address D3
• ICS clock will acknowledge
• ICS clock will send the byte count
• Controller (host) acknowledges
• ICS clock sends first byte (Byte 0) through byte 5
• Controller (host) will need to acknowledge each byte
• Controller (host) will send a stop bit
Controller (Host)
Address
Start Bit
Stop Bit
2
D3
C programming.
ACK
ACK
ACK
ACK
ACK
ACK
ACK
(H)
How to Read:
ICS (Slave/Receiver)
ICS9248-92
Byte Count
Byte 0
Byte 1
Byte 2
Byte 3
Byte 4
Byte 5
ACK
(H)