AD7885AAP-REEL Analog Devices Inc, AD7885AAP-REEL Datasheet - Page 14

• Manufacturer Part Number: AD7885AAP-REEL
• Description: IC ADC 16BIT SAMPLING HS 44-PLCC
• Manufacturer: Analog Devices Inc

Specifications of AD7885AAP-REEL

• Rohs Status: RoHS non-compliant
• Number Of Bits: 16
• Sampling Rate (per Second): 166k
• Data Interface: Parallel
• Number Of Converters: 2
• Power Dissipation (max): 325mW
• Voltage Supply Source: Dual ±
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 44-PLCC

AD7884/AD7885
AD7884 to ADSP-2101 Interface
Figure 21 shows an interface between the AD7884 and the
ADSP-2101. Conversion is initiated using a timer that allows
very accurate control of the sampling instant. The AD7884 BUSY
line provides an interrupt to the ADSP-2101 when conversion is
completed. The RD pulsewidth of the processor can be programmed
using the Data Memory Wait State Control register. The result
can then be read from the ADC using the following instruction:
where MR0 is the ADSP-2101 MR0 register, and ADC is the
AD7884 address.
DMA13–DMA0
ADSP-2101
DMD15–DMD0
Figure 21. AD7884 to ADSP-2101 Interface
IRQn
DMS
RD
MR
DECODE LOGIC
EN
0 =
ADDRESS BUS
DATA BUS
ADDRESS
DM ADC
(
TIMER
)
CONVST
CS
BUSY
RD
DB15–DB0
AD7884
–14–
Standalone Operation
If CS and RD are tied permanently low on the AD7884, then,
when a conversion is completed, output data will be valid on the
rising edge of BUSY. This makes the device very suitable for
standalone operation. All that is required to run the device is an
external CONVST pulse that can be supplied by a sample timer.
Figure 22 shows the AD7884 set up in this mode with the BUSY
signal providing the clock for the 74HC574 three-state latches.
Digital Feedthrough from an Active Bus
It is very important when using the AD7884/AD7885 in a
microprocessor based system to isolate the ADC data bus from
the active processor bus while a conversion is being executed.
This yields the best noise performance from the ADC. Latches
like the 74HC574 can be used to do this. If the device is connected
directly to an active bus, then the converter noise typically increases
by a factor of 30%.
Figure 22. Standalone Operation
AD7884
HBEN
DB15–DB8
A0
DB7–DB0
CONVST
BUSY
CS
RD
TIMER
74HC574
74HC574
CLK
CLK
REV. E