CS4354-CSZ Cirrus Logic Inc, CS4354-CSZ Datasheet - Page 21

• Manufacturer Part Number: CS4354-CSZ
• Description: IC DAC 24BIT SRL 14SOIC
• Manufacturer: Cirrus Logic Inc

Specifications of CS4354-CSZ

• Package / Case: 14-SOIC (3.9mm Width), 14-SOL
• Number Of Bits: 24
• Data Interface: Serial
• Number Of Converters: 1
• Voltage Supply Source: Single Supply
• Power Dissipation (max): 65mW
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Conversion Rate: 192 Ksps
• Resolution: 24 bit
• Interface Type: Serial
• Operating Supply Voltage: 5 V
• Operating Temperature Range: - 40 C to + 85 C
• Maximum Power Dissipation: 65 mW
• Mounting Style: SMD/SMT
• Number Of Dac Outputs: 2
• Number Of Dacs: 2
• Output Voltage: 5 V
• Power Consumption: 50 mW
• Supply Current: 5 V
• Thd Plus Noise: - 86 dB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Settling Time: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 598-1808; CS4354-CSZ

DS895A2
6. PARAMETER DEFINITIONS
Total Harmonic Distortion + Noise (THD+N)
Dynamic Range
Interchannel Isolation
Interchannel Gain Mismatch
Gain Drift
The ratio of the RMS value of the signal to the RMS sum of all other spectral components over the specified
bandwidth (typically 10 Hz to 20 kHz), including distortion components. Expressed in decibels.
The ratio of the full-scale RMS value of the signal to the RMS sum of all other spectral components over the
specified bandwidth. Dynamic range is a signal-to-noise measurement over the specified bandwidth made
with a -60 dBFS signal. 60 dB is then added to the resulting measurement to refer the measurement to full
scale. This technique ensures that the distortion components are below the noise level and do not affect the
measurement. This measurement technique has been accepted by the Audio Engineering Society, AES17-
1991, and the Electronic Industries Association of Japan, EIAJ CP-307.
A measure of crosstalk between the left and right channels. Measured for each channel at the converter's
output with all zeros to the input under test and a full-scale signal applied to the other channel. Units in deci-
bels.
The gain difference between left and right channels. Units in decibels.
The change in gain value with temperature. Units in ppm/°C.
CS4354
21