101-0521 Rabbit Semiconductor, 101-0521 Datasheet - Page 17

• Manufacturer Part Number: 101-0521
• Description: MODULE RABBITCORE RCM3210
• Manufacturer: Rabbit Semiconductor

Specifications of 101-0521

• Module/board Type: MPU Core Module
• For Use With/related Products: RCM3210
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 101-521; 101-521

2.2.1 Step 1 — Attach Module to Prototyping Board
Turn the RCM3200 series module so that the Ethernet jack extends off the Prototyping
Board, as shown in Figure 2 below. Align the pins from the headers on the bottom side of
the module into header sockets RCM2JA and RCM2JB on the Prototyping Board (these
sockets were labeled J12 and J13 on earlier versions of the Prototyping Board).
Although you can install a single module into either the
on the Prototyping Board, all the Prototyping Board features (switches, LEDs, serial port
drivers, etc.) are connected to the
MASTER
Press the module’s pins firmly into the Prototyping Board header sockets—press down in
the area above the header pins using your thumbs or fingers over the connectors as shown
in Figure 2. Do not press down on the middle of the RCM3200 series module to avoid
flexing the module, which could damage the module or the components on the module.
Should you need to remove the RCM3200 module, grasp it with your fingers along the sides
by the connectors and gently work the module up to pull the pins away from the sockets
where they are installed. Do not remove the module by grasping it at the top and bottom.
User’s Manual
NOTE: It is important that you line up the pins from the headers on the bottom side of the
Figure 2. Install the RCM3200 Series Module on the Prototyping Board
RCM3200 module exactly with the corresponding pins of header sockets RCM2JA and
RCM2JB on the Prototyping Board. The header pins may become bent or damaged if
the pin alignment is offset, and the module will not work. Permanent electrical damage
to the module may also result if a misaligned module is powered up.
position.
MASTER
position — install a single module in the
MASTER
or the
SLAVE position
11