101-0566 Rabbit Semiconductor, 101-0566 Datasheet - Page 45

• Manufacturer Part Number: 101-0566
• Description: COMPUTER SNGLBD BL2100 FRCTNLOCK
• Manufacturer: Rabbit Semiconductor

Specifications of 101-0566

• Module/board Type: Single Board Computer Module
• For Use With/related Products: BL2100
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

The following sample programs are found in the
•
•
4.2.3 A/D Converter Inputs
The following sample programs are found in the
•
•
•
•
•
4.2.4 D/A Converter Outputs
The following sample programs are found in the
•
•
User’s Manual
MASTER.C
letters to a slave BL2100. The slave will send back converted upper case letters back to
the master BL2100 and display them in the
the slave BL2100.
SLAVE.C
letters to a slave BL2100. The slave will send back converted upper case letters back to
the master BL2100 and display them in the
the master BL2100.
AD_CALIB.C
knownvoltages to generate two coefficients, gain and offset, which are rewritten into
the user block data area. The voltage that is being monitored is displayed continuously.
Make sure that you don't exceed the voltage range of the A/D converter input channel.
AD1.C
TLC2543 and TLC1543 A/D converter chips. The program reads the A/D internal volt-
ages and then uses the
AD2.C
tion. The program uses the
tored.
AD3.C
A/D driver. The program uses the
monitored on all the A/D channels using the low-level A/D driver.
AD4.C
driver. The program uses the
ples) that is being monitored on all the A/D converter channels using the low-level A/D
driver.
DACAL.C
using two known voltages, and defines the two coefficients, gain and offset, that will be
rewritten into the D/A converter's EEPROM simulated in flash memory.
DAOUT1.C
put voltage is computed using the calibration constants that are read from the EEPROM
simulated in flash memory.
NOTE: This sample program will overwrite the calibration constants set at the factory.
NOTE: This sample program will overwrite the calibration constants set at the factory.
—Demonstrates how to access the A/D internal test voltages in both the
—Demonstrates how to access the A/D channels using the
—Demonstrates how to access the A/D converter channels with the low-level
—Demonstrates how to use the A/D converter channels with the low-level A/D
—This program demonstrates a simple RS-485 transmission of lower case
—This program demonstrates how to recalibrate an D/A converter channel
—This program demonstrates a simple RS-485 transmission of lower case
—This program outputs a voltage that can be read with a voltmeter. The out-
—Demonstrates how to recalibrate an A/D converter channel using two
STDIO
STDIO
STDIO
window to display the RAW data.
STDIO
window to display the voltage that is being moni-
window to display the voltage (average of 10 sam-
window to display the voltage that is being
STDIO
STDIO
RS485
ADC
DAC
subdirectory in
subdirectory in
window. Use
window. Use
subdirectory in
MASTER.C
SLAVE.C
SAMPLES\BL2100
SAMPLES\BL2100
anaInVolt
SAMPLES\BL2100
to program
to program
func-
.
.
39
.